Holy Stone HS210 Instructions For Use Manual
Hide thumbs
Also See for HS210:
- User manual ,
- Instructions for use manual (32 pages) ,
- Instructions for use manual (14 pages)
Subscribe to Our Youtube Channel
Related Manuals for Holy Stone HS210
Summary of Contents for Holy Stone HS210
- Page 1 Instructions For Use V 1.0 HS210 +1(855) 888-6699 www.holystone.com eu@holystone.com (EU) usa@holystone.com (USA) jp@holystone.com (JP) ca@holystone.com (CA)
-
Page 3: Table Of Contents
Contents 1.0 Disclaimer & Warning ................. 2.0 Safety Guidelines .................. 3.0 Maintenance ..................4.0 Packing Contents .................. 5.0 Drone Details ..................6.0 Low Battery Warning ................. 7.0 Transmitter Functions ................. 8.0 Joystick Mode ..................9.0 Installation ..................10.0 Charging ....................11.0 Flight Pairing ...................... -
Page 4: Disclaimer & Warning
1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warning and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. -
Page 5: Flight Environment
④ Ensure to do a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear of the propeller, battery power and effectiveness of the indicator, etc. If after doing a complete check of the drone any problems are found, please refrain from using it until the problem has been resolved. -
Page 6: Operation Requirements
2.3 Operation Requirements ① DO NOT use this product to follow any moving vehicles. ② During the flight, turn off the motors only in case of an emergency. ③ Fly the drone back to you as soon as you are notified that the battery is running low. - Page 7 please remove batteries to prevent potential damage from to the drone battery leakage. ⑦ Only use the USB charging cable that comes with the drone to charge the battery. ⑧ DO NOT connect the battery directly to wall outlets or car cigarette -lighter sockets as this will damage your battery as they are a different voltage.
-
Page 8: Maintenance
3.0 MAINTENANCE ① Clean the product after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. ③ This device is not waterproof and must not be submerged or subjected in water under any circumstance. -
Page 9: Package Contents
4.0 PACKAGE CONTENTS Drone Transmitter Drone Battery USB Charger Propeller Screwdriver Instructions For Use V 1.0 HS210 +1(855) 888-6699 www.holystone.com usa@holystone.com (USA) eu@holystone.com (EU) ca@holystone.com (CA) jp@holystone.com (JP) Propellers Instructions For Spanner... -
Page 10: Drone Details
5.0 DRONE DETAILS Propeller A Propeller B TAIL HEAD Propeller B Propeller A 6.0 LOW BATTERY WARNING ① When the drone battery runs low, the LEDs on the drone will blink continuously. After about 1 minute or so the drone will automatically land on the ground. -
Page 11: Transmitter Functions
7.0 TRANSMITTER FUNCTIONS Power Indicator Speed Switch 360°Flip (Short press) (Short press) Circle Fly High Speed Rotation (Long press) (Long press) Left Joystick/ Right Joystick Trimmer One Key Start/ Headless Mode Landing ON/OFF Battery Cover Battery Compartment AAA Batteries (NOT included) - Install batteries carefully. -
Page 12: Joystick Mode
8.0 JOYSTICK MODE 8.1 MODE 2 (Left hand throttle MODE 2 will be the default setting.) Left Joystick Right Joystick Ascend Forward Descend Down Down Backward Left Right Left Right Fly to Fly to Rotate Rotate Left Right Left Right 8.2 MODE 1 To enter MODE 1, turn on the transmitter while holding the ( button. -
Page 13: Installation
9.0 INSTALLATION 9.1 Propeller HEAD See illustration above. An “A” “B” is printed on each propeller. Install the propeller to the motor shaft and press into place. Attention: The drone will not fly unless the correct propeller is installed on the correct motor shaft. Removal: Insert the propeller spanner between the propeller and the motor. -
Page 14: Charging
10.0 CHARGING USB Adapter (5V/2A) Charging Indicator USB Charger Power Bank Charging Port ① Connect the battery with the USB charger. ② Plug the charger into a USB charging port of a power bank or USB adapter (5V/2A). ③ Charging time: about 40-60 minutes. ④... -
Page 15: Flight
11.0 Flight - All of the operations shown in this manual are demonstrated using MODE 2. - You must keep your drone in visual line of sight all the time. If you can't see it, you can't control it. 11.1 Pairing HEAD TAIL ①... -
Page 16: Gyro-Calibration
11.2 Gyro-calibration Push the left and right joystick simultaneously to the lower left corner to calibrate the gyro. The LEDs on the drone will blink quickly and turn solid. You will hear 2 beeps from the transmitter when the calibration is completed. -
Page 17: One Key Landing
Takeoff Method 2: After pairing, pick up the drone and lay it flat on your palm. Gently toss the drone into the air, and it will hover in place. - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 11.4 One Key Landing Landing When the drone is in the air, you can press the (... -
Page 18: Functions Details
12.0 FUNCTION DETAILS 12.1 Emergency Stop The Emergency Stop function should only be used in case of emergency during the flight to avoid any of damage or injury. ① Press the upper left ( ) and upper right ( ) button of the transmitter at the same time, the motors will stop immediately and the drone drops to the ground. -
Page 19: Trimmer
12.2 Trimmer Trim adjustments are designed to counter drifts not caused by airflow. The Forward Trim If the drone tends to drift forward: 1. Press down the left joystick button and do not release it. 2. At the same time, push the right joystick backward one time. 3. -
Page 20: Speed Switch
12.3 Speed Switch This drone comes with 3 speed modes (Low/Medium/High). Press the ) button on the upper left of the transmitter to change the speed. The transmitter beeps once to indicate Low Speed, twice to indicate Medium Speed and three times to indicate High Speed. (The Low Speed is the default speed mode.) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 12.4 Altitude-Hold... -
Page 21: 360° Flip
12.5 360° Flip 10 ft After you get familiar with all the functions of the drone, you can try this amazing flip mode. When the drone is at least 10 ft from the ground, press down on the ( ) button, then push the right joystick in any direction. -
Page 22: Circle Fly
12.6 Circle Fly Press and hold the ( ) button for about 3 seconds, the drone will enter the Circle Fly mode. Exit the Circle Fly mode by long pressing the same button again or pushing the right joystick in any dircetion. - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 12.7 High Speed Rotation Press and hold the (... -
Page 23: Headless Mode
12.8 Headless Mode The Headless Mode is a great training tool for beginner pilots. It is also useful when the drone is too far from the pilot (which makes it difficult to tell its orientation). It keeps the drone traveling forward, backward, left, or right when you move the right joystick in those directions, regardless of which way the front of the head of the drone points to. -
Page 24: Specification
Or, when its head is pointing to you, if you push the right joystick to the left, the drone will fly to your left. 13.0 SPECIFICATIONS DRONE Model: HS210 Weight: 24.8g/0.87oz Max Flight Time: 9 minutes (per battery) Motor Model: 0615 Operating Temperature Range:14°... -
Page 25: Usb Charging Cable
TRANSMITTER Operating Frequency: 2452-2474 MHz Max Flight Distance: 50 m (outdoors and unobstructed) Operating Temperature Range: 14° to 104°F Battery Type: 1.5V AAA Battery (Not included) USB CHARGING CABLE Input: 5 V/2A Rated Power: ≤10 W 14.0 CONTACT US Please do not hesitate to contact us if you need further support. 4:00 PM ~ 7:00 AM (PST) usa@holystone.com (USA) ca@holystone.com (CA) -
Page 26: General Information
15.0 GENERAL INFORMATION FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. - Page 27 WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with minimum distance 20cm between the radiator &...
- Page 28 CAN NMB-003 (B) RF Exposure Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonne- ments IC établies pour un environnement non contrôlé.
- Page 29 BATTERY WARNING: 1. Failure to follow all the instructions may result in serious injury, irreparable damage to the battery may cause a fire, smoke or explosion as well. 2. Always check the battery’s condition before charging or using it. 3. Please replace the battery if the battery is dropped or has any peculiar smell, overheating, discolouration, deformation or leakage happens.
- Page 30 11. Non-rechargeable batteries are not allowed to be recharged. Rechargeable batteries should be charged under adults’ supervision. 12. DO NOT mix different types of batteries including the new and used ones. 13. Batteries MUST be inserted with the correct polarity. 14.
-
Page 31: Manufacturer Information
Directive 2009/48/EC have been fully fulfilled on our product with indication below: Product Name: Remote control four axis series Model/Mark: HS210/HOLYSTONE The Statement of compliance is available at the following address: http://www.holystone.com/Download/CE/HS210_EU_DOC.pdf This product can be used among EU member states.
Need help?
Do you have a question about the HS210 and is the answer not in the manual?
Questions and answers