Playing Back The Added Sound - Canon MVX4 Instruction Manual

Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
When using the built-in microphone, do not connect any devices to the MIC
terminal.
You cannot use the DV terminal for audio dubbing.
If you add sound to a tape not recorded with this camcorder, sound quality may
decrease.
Sound quality may decrease when you add sound to the same scene for more
than 3 times.
You can check the picture on the LCD screen.
When you connect an audio device, check the sound via built-in speaker.
When you use a microphone, you can check the sound with headphones
connected to the camcorder.
Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.

Playing Back the Added Sound

You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
MENU
AUDIO SETUP
( 63)
1. Set the camcorder to PLAY(VCR)•
2. Press the MENU button and select [AUDIO SETUP]. Select [12bit
AUDIO], select a setting and press the MENU button.
• STEREO1: Plays back the original sound.
• STEREO2: Plays back the added sound.
• MIX/FIXED: Plays back Stereo 1 and Stereo 2 in the same level.
• MIX/VARI.: Plays back Stereo 1 and Stereo 2. The mix balance can be adjusted.
3. If you have selected [MIX/VARI.], adjust the mix level: Press the MENU
button and select [AUDIO SETUP]. Select [MIX BALANCE], adjust the
balance with the SET dial and press the MENU button.
Turn the SET dial down to increase the volume of Stereo 1 and up to increase the
volume of Stereo 2.
The camcorder resets to [STEREO1] when you turn the camcorder off. However,
the mix balance is memorized by the camcorder.
12bit AUDIO
mode.
E
105