Playing Back A Tape With Added Sound - Canon ZR100 Instruction Manual

62
Playing Back a Tape with Added
Sound
You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
~~)
I
AUDIO SETUP
H
12bit AUDIO· .. STERE01
1. Open the menu and select [AUDIO SETUP]. Select [12bit AUDIO],
select a setting and close the menu.
• STERE01: Plays back the original sound.
• STERE02: Plays back the added sound.
• MIX/FIXED: Plays back Stereo 1 and Stereo 2 in the same level.
• MIXNARI.: Plays back Stereo 1 and Stereo 2. The mix balance can be adjusted.
2. If you have selected [MIXNARI.], adjust the mix level: Open the menu
and select [AUDIO SETUP]. Select [MIX BALANCE], adjust the balance
with the SET dial and close the menu.
Turn the SET dial down to increase the volume of Stereo 1 and up to increase the
volume of Stereo 2.
o
The camcorder resets to [STERE01] when you turn the camcorder off.
However, the mix balance is memorized by the camcorder.
o
Audio dubbing cannot be performed with your camcorder.