List Of Messages - Canon MVX4 Instruction Manual

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE
CASSETTE
CHECK THE INPUT
CONDENSATION HAS
BEEN DETECTED
CONDENSATION HAS
BEEN DETECTED
REMOVE THE
CASSETTE
TAPE END
CHECK THE CASSETTE
[WRONG FORMAT]
WRONG FORMAT
PLAYBACK NOT
POSSIBLE
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT
PROTECTED DUBBING
RESTRICTED
Memory Card Related Messages
Message
NO CARD
THE CARD IS SET FOR
ERASURE PREVENTION
NO IMAGES
CARD ERROR
130
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the
position of the protect switch.
Camcorder stopped operating to protect the tape. Unload and
reload the cassette.
DV cable or USB cable is not connected, or the connected digital
device is turned off.
Condensation has been detected in the camcorder.
Condensation has been detected in the camcorder. Unload the
cassette.
Tape reached the end. Rewind the tape or replace the cassette.
You attempted to perform audio dubbing on a tape recorded in
HDV format.
You attempted to play back a tape recorded in HDV format.
You attempted to perform audio dubbing on a tape recorded in a
mode other than the SP mode.
You attempted to perform audio dubbing on a tape recorded in 16-
bit or 12-bit 4-channel sound.
You attempted to perform audio dubbing on a tape with a blank
section.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording.
Memory card not is inserted into the camcorder.
SD Memory Card is set for erasure prevention. Replace the card
or change the position of the protect switch.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
play back the image.
The error may be temporary. If the message disappears after 4
seconds and " " flashes red, turn the camcorder off, remove the
card and reinsert the card. If "
continue recording/playback.
Explanation
Explanation
" changes to green, you can
24
15
134
18
99
119
129
129
–
–
–
104
104
104
137
101
101
19
19
–
–