Chapter 6 Device Debugging; Set Pc Network - HikRobot SC1000 Series Quick Start Manual

SC1000 Series Vision Sensor Quick Start Guide
Before debugging the device, you need to set the PC's network, install the client software
and log in to the device.

6.1 Set PC Network

To ensure stable image transmission and normal communication between the PC and the
device via client software, you need to set the PC network before using the client software.
Steps
Note
For different Windows versions, the specific setting path and interface may differ. Please
refer to the actual condition.
1. Go to PC network settings page: Start → Control Panel → Network and Internet →
Network and Sharing Center → Change adapter settings.
2. Select NIC and set the IP obtainment mode.
● Select Obtain an IP address automatically to get an IP address of the PC automatically.
● Or select Use the following IP address to set an IP address for the PC manually.
Note
It is recommended to use the static IP address to reduce time for searching the device.

Chapter 6 Device Debugging

Figure 6-1 Set PC Network
11