Device Selection Menu
When you press DEVICE on the TV's remote control, the Device Selection menu (Figure 7) displays. If NetCommand®
has not been set up, the Device Selection menu allows you to select an input for viewing. If NetCommand is set up, the
Device Selection menu allows you to select the device for viewing, select audio from the TV speakers or A/V receiver,
power compatible devices On or Off, and verify the destination of signals. On the Device Selection menu, the device or
input currently displayed appears as a gold-colored icon.
Figure 7. Device Selection Menu with NetCommand
Power On/Off Devices
Devices that have separate On and Off remote control
buttons will power On automatically when you select
the device and will power Off when you turn off the TV.
For devices that do not power On or Off automatically,
display the Device Selection menu, press ADJUST
to highlight the device icon and press POWER on
the remote control. For the A/V receiver, press AUDIO
to move the navigation to the Audio Section. Highlight
the A/V receiver icon and press POWER. If you
press POWER on the remote control when the Device
Selection menu is not displayed, the TV will turn Off.
To select another device or input, press ADJUST
on the TV's remote to move the highlight.
Press ENTER to select the device to view and
hear. The TV inputs are automatically changed. If
NetCommand is set up, the inputs on compatible A/V
receivers are automatically changed at the same time.
The destination of the device highlighted in the Device
Section is displayed here as a TV icon.
The Connection Section shows the recording in
progress and the device that is recording from the
source. For example, if the Digital VCR (D-VCR) is
currently recording, when you move the highlight
to the Ant-1 icon, the D-VCR icon will appear in the
Connection Section. This icon will disappear when
you move the highlight to another icon, press CANCEL
to stop recording.
Chapter 4. IEEE 1394 Devices and NetCommand-Controlled Recordings
When a NetCommand pre-memorized or learned IR
controlled A/V receiver has been connected to the TV
and added to NetCommand Setup, an AVR icon will
appear in the audio section. Press AUDIO to change
navigation to the audio section. Then press ADJUST
to select the TV speakers icon or the A/V
receiver icon. Press ENTER to change the audio
selection. Press DEVICE to return the navigation to the
PIP Device Selection Menu
The PIP Selection menu displays when you press the
PIP DEVICE button on the remote control. This menu
has the same general format as the Device Selection
menu. The source for the Video Section is the sub
picture and the Audio and Connection Sections are not
to move the highlight to the
device to show in the PIP screen, then press ENTER.
Device icons that are grayed out are not available for
use as PIP sources or with the current source.
Figure 8. PIP Device Selection Menu
If a device does not respond to separate On or
Off remote control signals, the manufacturer
has not provided that ability for the device.