Antenna With A Single Lead; Antennas With Separate Uhf And Vhf Leads - Brother HL-2600CN Owner's Manual

Connecting an Antenna with a Single Lead or Antennas with
Separate UHF and VHF Leads

Antenna with a Single Lead

(not for use with CableCARD™)
Figure 3
For antennas with flat twin leads
A 300-Ohm to 75-Ohm transformer is required. This is not
included with the TV, but is available at most electronics stores.
1. For an antenna with flat twin leads, connect the
300-Ohm twin leads to the 300-Ohm to 75-Ohm
transformer.
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For cable or antenna with coaxial lead
Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
Figure 3. Connecting a Single Antenna
IR EMITTER
Net Command
DTV/CABLE/
VHF/UHF
DIGITAL
AUDIO
ANT 1 / MAIN ANT 2 / AUX OUTPUT
Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Antennas with Separate UHF and VHF
Leads
Figure 4
A UHF/VHF combiner is required. This is not included with the
TV.
1. Connect the UHF and VHF antenna leads to the UHF/
VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV back
panel.
Figure 4. Connecting separate UHF and VHF Antennas
Chapter 2. Connecting
COMPONENT
YPbPr (480i/480p/720p
INPUT
1 2
1 2
S-VIDEO
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
IR EMITTER
Net Command
DTV/CABLE/
VHF/UHF
DIGITAL
AUDIO
ANT 1 / MAIN ANT 2 / AUX OUTPUT
25