Brother MFC-9460CDN User Manual page 130

Error Message
Condensation
Connection Fail
Cooling Down
Wait for a while
Cover is Open
Cover is Open
Cover is Open
DIMM Error
Disconnected
Cause
One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change.
You tried to poll a fax machine
that is not in Polled Waiting mode.
The temperature of the drum unit
or toner cartridge is too hot. The
machine will pause its current
print job and go into cooling down
mode. During the cooling down
mode, you will hear the cooling
fan running while the LCD shows
Cooling Down, and Wait for
a while.
The front cover is not completely
closed.
The ADF cover is not completely
closed.
The ADF is open while loading a
document.
The fuser cover is not completely
closed or paper was jammed in
the back of the machine when
you turned on the power.
 The DIMM is not installed
correctly.
 The DIMM is broken.
 The DIMM does not meet the
required specifications.
The other person or other
person's fax machine stopped the
call.
Action
Leave switched ON. Fully open the front
cover. Wait 30 minutes, switch OFF and
close cover, then switch ON. If this does not
clear the error, call Brother Customer
Service.
Check the other fax machine's polling setup.
Make sure that you can hear the fan in the
machine spinning and that the exhaust
outlet is not blocked by something.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use
it for several minutes.
If the fan is not spinning, disconnect the
machine from the power for several minutes,
then reconnect it.
Close the front cover of the machine.
Close the ADF cover of the machine.
Close the ADF cover of the machine, then
press Stop/Exit.
 Close the fuser cover of the machine.
 Make sure paper is not jammed inside
the back of the machine, and then close
the fuser cover and press Black Start or
Color Start.
 Turn off the machine and remove the
DIMM.
 Confirm the DIMM meets the required
specifications. (See Memory board in
Appendix B of the Advanced User's
Guide.)
 Re-install the DIMM correctly. Wait a few
seconds, and then turn it on again.
 If this error message appears again,
replace the DIMM with a new one. (See
Installing extra memory in Appendix B of
the Advanced User's Guide.)
Try to send or receive again.
Troubleshooting
B
93