Changing Fax Resolution; Dual Access (Black & White Only) - Brother MFC-9440CN User Manual

Changing fax resolution

The quality of a fax can be improved by
changing the fax resolution. Resolution can
be changed for the next fax or for all faxes.
To change the fax resolution for the
next fax
a
Make sure you are in Fax mode
b
Load your document.
c
Press Resolution, then a or b to
choose the resolution.
Press OK.
To change the default fax resolution
a
Make sure you are in Fax mode
b
Press Menu, 2, 2, 2.
Setup Send
2.Fax Resolution
c
Press a or b to choose the resolution
you want.
Press OK.
Note
You can choose four different resolution
settings for black & white faxes and two for
color.
Black & white:
Standard Suitable for most typed
documents.
Fine Good for small print and transmits a
little slower than Standard resolution.
S.Fine Good for small print or artwork
and transmits slower than Fine resolution.
Photo Use when the document has
varying shades of gray or is a photograph.
This has the slowest transmission time.
Color:
5
Standard Suitable for most typed
documents.
Fine Use when the document is a
photograph. The transmission time is
slower than Standard resolution.
5
If you choose S.Fine or Photo and then
use the Color Start key to send a fax, the
.
machine will send the fax using the Fine
setting.
Dual access
(black & white only)
You can dial a number, and start scanning the
5
fax into memory—even when the machine is
sending from memory, receiving faxes or
.
printing PC data. The LCD shows the new job
number.
The number of pages you can scan into the
memory will vary depending on the data that
is printed on them.
Note
• Your machine normally uses dual access.
However, to send a color fax, the macine
will send the document in real time (even
if Real Time TX is set to Off).
The number of pages you can scan into
the memory will vary depending on the
data that is printed on them.
• If you get an Out of Memory message
while scanning the first page of a fax,
press Stop/Exit to cancel scanning. If you
get an Out of Memory message while
scanning a subsequent page, you can
press Black Start to send the pages
scanned so far, or press Stop/Exit to
cancel the operation.
Sending a fax
5
5
35