Kolpin Outdoors 15-2610 Assembly & Owners Manual

Kolpin Outdoors 15-2610 Assembly & Owners Manual

Mid-mount kit for kawasaki atv's

Advertisement

MID-MOUNT KIT
FOR KAWASAKI ATV's
P/N 15-2610
ASSEMBLY / OWNERS MANUAL
Application
PLOW PUSH FRAME NO. 15-0070, 33-0000 or 33-0070
Before you begin, please read these instructions and check to be sure all parts and tools are
accounted for. The following instructions contain details required to install and service the contents
of this kit.
© 2017 Kolpin Outdoors Inc.
REV 07

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 15-2610 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kolpin Outdoors 15-2610

  • Page 1 Before you begin, please read these instructions and check to be sure all parts and tools are accounted for. The following instructions contain details required to install and service the contents of this kit. © 2017 Kolpin Outdoors Inc. REV 07...
  • Page 2: Safety Information

    IN UP POSITION. DO NOT ATTEMPT TO RAISE BLADE BY HAND; USE THE LIFT MECHANISM ONLY. LOWER BLADE TO DOWN POSITION WHEN BLADE AND ATV/UTV ARE NOT IN USE. READ BLADE'S INSTRUCTION SHEETS AND ATV/UTV OWNER MANUAL. © 2017 Kolpin Outdoors Inc. REV 07...
  • Page 3: Kit Contents

    Clevis Pin, Zinc Plated, 10mm x 35mm PUR1209 Hair Pin, Zinc Plated, #3 PUR1249 Hex Locknut, Zinc Plated, M8-1.25 PUR3068 U-Bolt, Zinc Plated, M8-1.25 x 30mm x 50mm Flat Washer, Zinc Plated, M8 PUR3087 Instruction Guide (not shown) © 2017 Kolpin Outdoors Inc. REV 07...
  • Page 4: Before You Begin

    Description P/N CYC5775 Clevis Pin, Zinc Plated, 10mm x 35mm Hair Pin, Zinc Plated, #3 Hex Locknut, Zinc Plated, M8-1.25 U-Bolt, Zinc Plated, M8-1.25 x 30mm x 50mm Flat Washer, Zinc Plated, M8 © 2017 Kolpin Outdoors Inc. REV 07...
  • Page 5 Position the blade mount (item #1) into place and fasten to vehicle with washers (item #6) and locknuts (item #4) as shown in parts list on page 3 and image below. (See illustration 1-1). Tighten locknuts to specification. 8MM FASTENER TORQUE: 17 ft. lbs. (23 Nm) #4, #6 Ill. 1-1 © 2017 Kolpin Outdoors Inc. REV 07...
  • Page 6: One Year Limited Warranty

    Most hardware is general in nature and is easily obtained locally. Be sure to replace with minimum metric class 8.8 specification. Kolpin Outdoors, Inc. Telephone: (763)-478-5800 Toll Free: (877)-956-5746 Fax Number: (800)-245-7569 www.kolpin.com Email: customerservice@kolpin.com © 2017 Kolpin Outdoors Inc. REV 07...

Table of Contents