Download Print this page
Pandora 2147 Installation Manual

Pandora 2147 Installation Manual

Security-service and remote start system for toyota corolla xii e210 2019

Advertisement

Quick Links

Installation guide of Pandora security-service and remote start system for
Toyota Corolla XII E210 2019 - ...
Push-to-Start button
Hybrid transmission
Model code: 2147
WARNING! This installation manual has the status of recommendation.
This system MUST BE installed by a certified technician.
Connect the wires only when the base unit is disconnected.
It's prohibited to place the wires near sharp elements and moving parts of a car. Wiring through the
holes should be passed using special rubber bushings.
The car's electrical scheme and wire colors may differs from the information shown in this guide, so
suggested connection points MUST BE checked before installation.
www.pandorainfo.com
e-mail:
support@pandorainfo.com
Page 1

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2147 and is the answer not in the manual?

Questions and answers

Summary of Contents for Pandora 2147

  • Page 1 Installation guide of Pandora security-service and remote start system for Toyota Corolla XII E210 2019 - ... Push-to-Start button Hybrid transmission Model code: 2147 WARNING! This installation manual has the status of recommendation. This system MUST BE installed by a certified technician.
  • Page 2 Switch the base unit to program mode by entering «service PIN-code» using Valet button (1-1-1-1 by default); • Update the firmware of the base unit, then update Bluetooth firmware using «Pandora Specialist» app, choose the vehicle model and adjust the settings of security system in accordance with the «System settings»...
  • Page 3: Commands And Statuses

    Statuses Commands Model code 2147 • • • • • • • • • • • • • • - - • - - - - • - • • - - - - - - - • CAN 1...
  • Page 4 BACK SECURITY SYSTEM SETTINGS Name Item Setting Note 1.1.1 Setting of the warning level of the shock sensor Test the sensitivity after Setting of the alarm level of the shock sensor 1.1.2 installation. Adjust if Setting of the alarm level of the motion sensor 1.1.3 necessary 1.1.4...
  • Page 5 BACK CONNECTION POINTS LOCATION «Smart Key» module «Gateway» module Fig.1 - BCM module location, left of steering column. Fig.2 - «Gateway» and «Smart Key» ECU’s location, behind the glove box. Pin №18, white/black «GND» «I 1» Smart Key connector Pin №17, brown - +12V Fig.3 - «I 1»...
  • Page 6 BACK CONNECTION POINTS LOCATION Don’t use an ignition output from Smart Key ECU to supply «I 1» Smart Key an additional load (relays, connector dashcams etc.), this is a low- current transistor output! Pin №12, green - Pin №15, red - SLP(-) Ignition (+) Fig.7 - «I 1»...
  • Page 7: Wiring Diagram

    Pin №17: purple Unlock (-) Use analog central lock control when it’s necessary to disarm the car from Pandora’s tag/fob/application. Change defaulted setting of vehicle’s theft deterrent system «Security control «I 84» BCM with mechanism key» from OFF to ON using dealer connector (Techstream) or similar scan tool.
  • Page 8 STOP Turn the ignition ON and OFF again. System will be rebooted after 5 sec. and will return to a normal operation. All described steps can be perfomed manually or in automated mode using «Pandora Specialist» application www.pandorainfo.com e-mail: support@pandorainfo.com Toyota Corolla XII E210 2019 - ...