Table of Contents
Advertisement
M. Installation of the Helmet Mount Assembly (Optional) to the
PASGT Helmet.
1. Remove mount assembly from the carrying case. Refer to Figure
2-5 for the helmet mount features.
Catch
Helmet
Buckle
Strap
Lever
Tilt
Adjustment
Side
Rear
Socket
Front Bracket
Button
Bracket
Figure 2-8. Helmet Mount Features
2. With the catch in forward most position, place the strap over the
top of the helmet, center and hook the rear bracket onto the rear
of the helmet. Center the front bracket, hook in on the front of the
helmet and hold it in place. (See Figure 2-8.)
3. With the buckle-lever open, take up the slack in the strap using
catch. Close the buckle lever.
4. Place the helmet upside down with the helmet mount facing you.
NOTE
Steps 5 and 6 describe the installation of the nape strap to the chin-
strap. To accomplish these steps, it may he necessary to unthread
the chinstrap from the helmet.
5. Thread the chinstrap through the right end of nape strap and
snap nape strap fastener tab closed. (Refer to Figure 2-9.)
6. Thread chin strap through the left end of nape strap and snap
nape strap fastener tab closed. (Refer to Figure 2-9.).
2-19
Advertisement
Table of Contents
