Table of Contents
Advertisement
Browpad
Headband
Socket
Assembly
Socket
Release
Button
Figure 2-7. PVS-7 Head Mount Adjustments
1. Prior to donning the head mount, loosen the four chin straps so
the ends of each strap arc approximately two inches from the slid-
ing bar buckles (See Figure 2-7)
2. Snap the front and rear snaps in place.
NOTE
If the head mount is too loose, remove the attached thin brow pad
and replace with either the medium or large brow pad, stored in the
carrying case. Refer to Chapter 3, paragraph 3-4 for removal and
replacement of the brow pads.
3. With both hands, grasp the neck pad assembly and pull the har-
ness over your head and the neck pad down to the back of your neck.
Chin Cup
Neckpad
Chin Strap
Adjustment
Sliding Bar
Buckles
2-17
Advertisement
Table of Contents
