Table of Contents
Advertisement
Location
100-170
D506
D507
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
D447
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge to
the base of the appliance and remove the hinge itself;
be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to the
appliance and remove the hinge itself.
14
Fig. 1
This appliance is de-
signed to be built-in
to a space having the
dimensions given in
Fig. 1.
Fig. 2
The height of the ap-
pliance can be al-
tered if required by
means of adjustable
feet situated at its
base (Fig. 2).
Fig. 3
Carefully lean the ap-
pliance on its back
and remove the plas-
tic insert (Fig. 3).
D510
Remove and refit the other hinge on the upper part of
the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and fit
the insert supplied with the appliance on the opposite
side.
Fitting a decorative door panel
Important: The components needed to fit the dec-
orative panel have been pre-fitted on the appli-
ance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large
top bracket by unscrewing the screws and adjust-
ing pins pre-fitted on the appliance door. The small
bottom bracket need not be removed.
A
=
=
D467
Keeping the appliance central in the recess, slide it in
until its back touches the wall.
With a tape measure (or similar instrument), measure
distance (A) between the top edge of the door and the
top edge of the decorative panel, placing it next to the
recess.
Fig. 4
Take the hinge re-
moved from the up-
per part of the appli-
ance on the opposite
side (see Fig. 4), and,
using the screws re-
moved from the lower
part, fix it to the base
of the appliance it-
self.
Fig. 5
Place the appliance
in the position where
it is to be built in
(Fig. 5).
The appliance is fit-
ted with adjustable
feet; screw the front
and rear feet in or out
to adjust the height
of the appliance to
that of the recess.
Advertisement
Table of Contents
