Under no circumstances should solid ice tioning of the appliance and the relevant warnings. be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. See defrost These warnings are provided in the interest of instructions.
Before plugging in, ensure that the voltage and fre- (latch) on the door or lid, be sure to make that quency shown on the serial number plate correspond spring lock unusable before you discard the old to your domestic power supply.
D510 100-170 D506 Remove and refit the other hinge on the upper part of the appliance on the opposite side. Fig. 2 Fix the two front screws into the upper and lower hinges (Fig. 4).
Page 6
fixings. sides and that its dis- Cover the visible part...
150÷185 If the base plate is and the upper hinge. between 150 and O n c e t h e f re e z e r D520 185 mm high, cut it door has been remo- as shown in Fig. 14.
When first starting-up or after a period out of use, be- frost to form on the rear wall. In this case the dial fore putting the products in the compartment let the must be set to a higher temperature to allow auto-...
Fill these trays with water, then put them in the freezer follows: compartment. pull out the plug from the wall socket or turn the ther- Do not use metallic instruments to remove the trays mostat knob to the «O» setting;...
The light inside the refrigerator compartment is easy to get at through the opening in the light holder. Warning If the light does not come on when the door is open, This appliance contains hydrocarbons in its cooling check that it is screwed into place properly.
Need help?
Do you have a question about the JKU6031 and is the answer not in the manual?
Questions and answers