Table of Contents
Advertisement
D468
Secure the bracket with the screws supplied.
Take care not to damage the front face of the panel
whilst working.
B
D532
1
B
C
2
D533
Insert the securing screws (C) through elongated
holes (2) and fix the panel without tightening the
screws (Fig. 8).
D471
Fig. 6
Lay the panel face
down (Fig. 6). Posi-
tion the top bracket
on the panel, making
sure that there is an
equal distance be-
t w e e n i t a n d t h e
A
sides and that its dis-
-1cm
tance from the top
edge is equal to dis-
tance (A) less 1 cm.
Fig. 7
Insert the adjusting
pins (B-Fig. 7) into
their locations in the
door and screw them
in.
Fig. 8
Hook the decorative
panel onto the top
part of the door, in-
serting the pins (B)
(on the door) into the
elongated holes (1)
(in the top bracket
fitted to the panel)
(Fig. 8).
Fig. 9
Once the top of the
panel has been cor-
rectly positioned, fix
it through the holes in
the bottom bracket,
without tightening the
screws (Fig. 9).
D
D472
in the locations provided in the bracket.
D517
820
870
170
220
D518
ventilation duct until they click. The plate can be adju-
sted backwards or forwards in the holes (Fig. 12).
Fig. 10
Check the position
again by slackening
the screws and pins
then, once the best
position has been ob-
tained, fully tighten
all the fixings.
Cover the visible part
of the top bracket on
the panel with plastic
cover (D), inserting it
Fig. 11
Once the door has
been correctly aligned,
tighten the holding
nuts on the fixing
brackets and attach
the appliance to the
adjacent units and
the bottom of the work
surface (Fig. 11).
Fig. 12
If the appliance has
been fitted into a spa-
ce 820 mm high and
the maximum height
of the base plate is
100 mm, fit the front
cover plate by pu-
shing the two vertical
lugs into the rectan-
135
185
gular holes on the
bottom side of the
15
Advertisement
Table of Contents
