Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JUNO JKU6038
Summary of Contents for JUNO JKU6038
- Page 1 JKU 6038 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION 2222679-06...
-
Page 2: Table Of Contents
Installation Positioning / Electrical connection / Grid preparation ....... . . -
Page 3: Disposal
Instructions for the use of the instructions booklet Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance... -
Page 4: Hints
Meat can only be stored safely in this way for one or two days at the most. ¥ Cooked food, cold cuts, jelly, etc.: these should be well covered and can be stored on any of the glass shelves. ¥... -
Page 5: Maintenance Defrosting / Cleaning / Changing The Light Bulb
Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. Changing the light bulb ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. -
Page 6: Something Not Working
Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM SOLUTION Door does not close Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. -
Page 7: Door Reversal
Door reversal Warning! If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal... -
Page 8: Installation Positioning / Electrical Connection / Grid Preparation
Directives: - 87/308 EEC of 2/6/87 relative to radio Positioning interference suppression. ¥ Unpack the cabinet and check that it is in good - 73/23 EEC of 19.2.73 (Low Voltage condition and free of any transport damage. Directive) and subsequent modifications. -
Page 9: Building-In The Appliance Under A Worktop
Kitchen aperture. - To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet. - Position the two brackets as shown in the figure and replace the two securing screws. - Page 10 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet. - The rear feet are adjusted by turning the screw in the front kick plate to the left or right. Li89 4. If necessary, pads are supplied for the rear feet to 6.
- Page 11 LOWER PART OF KITCHEN FURNITURE PANEL clic clic UPPER PART OF KITCHEN FURNITURE PANEL...
-
Page 12: Fitting The Plinth
¥ For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the appliance position, leaving a remaining height of a=100 mm, b=150 ¥...
Need help?
Do you have a question about the JKU6038 and is the answer not in the manual?
Questions and answers