Table of Contents
Advertisement
INSTALLATION
Location
The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to a
separate earth in compliance with
current
regulations,
specialist technician.
The
M M anufacturer
responsibility
i i f
precautions a a re n n ot o o bserved.
This appliance complies with the
following E.E.C. Directives:
- 8 8 7/308 E E EC of 2/6/87 relative to radio
interference suppression.
- 7 7 3/23 E E EC of 19.2.73 (Low Voltage
Directive)
modifications;
-
8 8 9/336
(Electromagnetic
Directive)
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
consulting
d d eclines
t t he
a a bove
and
subsequent
E E EC
of
3.5.89
Compatibility
and
subsequent
Door reversibility
The appliance's door have been
locked in position for transport by
means of pins on both sides. According
to the door opening direction, remove
relevant pins at the top and at the
bottom.
Instructions for
totally built-in appliances
Building-in instructions
50 mm
a
a a ll
s s afety
D567
For safety reasons, minimum ventilation
must be as shown in Fig.
Attention: k k eep v v entilation o o penings
clear o o f o o bstruction.
It is necessary that the niche is
provided with a ventilation conduct
having the following dimensions:
Depth
Width
electrolux 33
min.
200 cm
2
min.
200 cm
50 mm
540 mm
2
Advertisement
Table of Contents
