Alula RE218T Quick Start Manual

Resolution Compatibles
Flood and Temp Sensor
sensor. It detects flood conditions and reports extreme
temperatures.
Features
• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE vent to prevent seal failure
®
• 5 year warranty
Enroll
by placing the panel into wireless enrollment mode and
removing the battery tabs, tampering the sensor, or manually
entering the sensor ID. NOTE, this sensor requires firmware
version 1.14 or later for GC2 Panel and 3.1 or later for
CG3. For older panel firmware versions, use the RE218
Honeywell Compatible Flood and Temp Sensor.
®
Panel Questions
Sensor Type
Equipment Type
Equipment Code
Sensor Age
Loop Number
Install
by placing the sensor in the location requiring flood or
temperature detection. If desired, the wall clip can be used
to secure the sensor.
Optional Screw Mounting
• Remove the wall clip from the sensor body.
• Secure the clip to a wall, baseboard or cupboard
using a #6 screw.
• Slide the sensor body down onto the wall clip until
it snaps into place.
Sensor detects
extreme temperature conditions.
Temperature Trip Points
• Heat alarms when over 100°F (38°C)
• Heat restores when under 97°F (36°C)
• Freeze alarms when under 45°F (7°C)
• Freeze restores when over 48°F (9°C)
To replace the batteries,
the front slot and twist. Slide both old batteries out and the
new batteries in. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Verify proper enrollment and operation using your control panel's installation manual.
RE218T Flood & Temp Sensor
2GIG
is an integrated environmental
Flood
[08] 24 Hour
Aux. Alarm
[8] Water
[1065] 2GIG
Flood Sensor
[0] New
[1] Flood
water pooled under the sensor and reports
insert a flat blade screwdriver into
Compatible
™
Heat Freeze
[08] 24 Hour [08] 24 Hour
Aux. Alarm Aux. Alarm
[10] Temp. [6] Freeze
[1065] 2GIG [1065] 2GIG
Flood Sensor Flood Sensor
[0] New [0] New
[2] Heat [3] Freeze
Wall Clip
Mounting Screw Hole
Front slot
I