Hollyland Solidcom M1 User Manual page 26

Product Installation
Beltpack Installation
1. Open the battery compartment and insert the battery, as shown in the above
diagram.
2. Toggle the power switch to turn on the beltpack.
3. After the beltpack state changes from LOST to TALK, you are ready to talk. To
enter the mute mode, press the TALK button on the top of the beltpack. In this
case, you can hear other beltpack users but cannot talk with them. To talk with
them, simply press the button again to turn off the mute function.
4. The beltpack supports two types of headphone interfaces: 3.5mm and 0B8. You
can choose the interface based on your specific needs.
5. When other intercom systems are connected via the 4-wire or 2-wire interface,
you can enter the base station menu to adjust the input and output gain for a
balanced gain across the entire intercom system.
6. Because the battery will enter sleep mode after extended storage, you are
advised to fully charge and discharge the beltpack for the first three times of use.
Repairing
The beltpack number may be lost due to misoperations or other reasons. In this
case, you can connect the beltpack to the base station using a USB-A to USB-C
cable, select Pair on the beltpack, and select an available number to confirm pairing.
Then, the message " Pairing... " will be displayed on the display screen of the base
station and the beltpack. Wait until the message " Pairing Successful " is displayed on
the screens before unplugging the cable from the base station and the beltpack.
23