Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Amico AC-400C
Summary of Contents for Amico AC-400C
- Page 1 Operation & Maintenance Manual AC-400C...
-
Page 2: Table Of Contents
Lowering the Siderails Raising the Siderails Central Locking System Locking the Bed Unlocking the Bed Using the CPR Release Lever Electrical Standard Features Troubleshooting Preventive Maintenance Cleaning 9-10 Bleach Cleaning Instructions Mattress Cleaning Instructions Technical Specification Warranty Policy Amico Beds Corporation... -
Page 3: Intended Use
The motions of the AC-400C are achieved by independent DC electric motors through controls located on the siderails of the bed allowing positions to be changed. The motors are equipped with overheat protection. -
Page 4: Features
Avoid sitting at the extreme ends of the bed (back rest and knee gatch) • It is recommended not to use water or silicone surfaces in order not to exceed the maximum weight limit of 550 lbs (250 kg) Amico Beds Corporation... -
Page 5: Siderail Controls
Press on this button to raise the fowler and knee gatch section to the desired position Trendelenburg Press on this button to place the bed in the desired reverse Trendelenburg position Reverse Trendelenburg Press on this button to place the bed in the desired Trendelenburg position www.amico.com... -
Page 6: Installation And Removal Of The Head/Foot Board
NOTE: Patients should be monitored intermittently to ensure correct patient positioning on the bed and proper usage of siderails. Amico Beds Corporation... -
Page 7: Central Locking System
It’s recommended that the fowler section is completely lowered to a flat position when the CPR handle is used. Electrical The AC-400C is comprised of four 24V DC LINAK actuator to enable the following motions to be achieved: • Head Up •... -
Page 8: Standard Features
Measure voltage level and drops too quickly if so, proceed to have batteries replaced. If the above troubleshooting step are not working, contact your Amico Sales Executive for support. Siderail controls stop working upon... -
Page 9: Preventive Maintenance
(PM) and testing for Joint Commission on Accreditation of Health Care Organizations (JCAHO). PM and testing not only meet JCAHO requirements but will help ensure of a long, operative life for the AC-400C bed. Preventive maintenance will minimize downtime due to excessive wear. -
Page 10: Mattress Cleaning Instructions
Set the bed on brake by pressing on the brake pedals to the Brake position During Cleaning • Do not use abrasive cleaning products • Do not use oil based products • Do not use a steam cleaner, washing tunnel, high-pressure spray or hose Amico Beds Corporation... -
Page 11: Technical Specification
Amico Beds Corporation warrants its Patient Equipment to be free from defects in material and workmanship for a period of twelve (12) months from the date of shipment. Within this period Amico Beds Corporation will provide the parts for repair or replacement of defective parts at Amico Beds Corporation cost. - Page 12 Amico Beds Corporation | 85 Fulton Way, Richmond Hill, ON L4B 2N4, Canada Toll Free Tel: 1.877.462.6426 | Tel: 905.764.0800 | Fax: 905.764.0862 Email: info@amico.com | www.amico.com AB-OM-AC-400C-BED 12.13.2022...
Need help?
Do you have a question about the AC-400C and is the answer not in the manual?
Questions and answers