Description (Fig. 1); Technical Characteristics; Safety Warnings; Electrical Connection - Fagor TRV-300 Instructions For Use Manual

1. DESCRIPTION (Fig. 1)

A. Function selector
B. Temperature selector
C. Light
D. Air flow grill
E. Transport handle
F. Cable tidy

2. TECHNICAL CHARACTERISTICS

Wattage: 2000 W
Voltage: 230 V~50 Hz

3. SAFETY WARNINGS

• Leave at least 1 metre between the
appliance and all furniture, sofas etc.
which could be close to the appliance.
• Do not switch the appliance on when
resting on walls, furniture, etc.
• If the appliance is used in the bathroom,
it must always be placed outside risk
areas as shown in figure 2.
• The appliance must be placed so that
the controls cannot be reached by the
person using the bath or the shower.
• Only use the appliance in vertical
position.
• Do not use it to dry clothing or obstruct
the air flow grill, to stop the appliance
from over-heating.
• The users should not replace the power
cable. This operation should only be
done by authorised personnel.
• Do not fit the appliance directly under a
plug socket.
• Do not cover the appliance during
operation to avoid reheating and
fire risks.
• Do not use the appliance in a room
which is smaller than 4 m
A safety device interrupts the operation
of the air handling unit in the event of
accidental overheating (e.g.: obstruction
of the air flow grill, motor not turning, or
turning slowly). In order to re-establish the
operation, unplug the appliance for a few
minutes, eliminate the cause of overheating
EN
and plug it in again. If the appliance still
does not operate normally, please contact
1 0 0 0 m m
an authorised Technical Assistance Centre.
This appliance is not designed for use by
people (including children) with reduced
physical, sensory or mental abilities,
or those with lack of experience or
knowledge, unless they are supervised or
instructed on the use of the appliance by a
person responsible for their safety.
Children are not aware of the dangers
of electrical appliances. It is therefore
necessary to supervise them when they are
using the appliance!
Do not cover the air inlet or outlet when
the appliance is operating.
• Before plugging in the appliance for the
• Make sure that the plug socket has
• This appliance is adjusted to the
On:
Choose the programme that you wish to
use by turning the function selector (A) to
the chosen position:
Position
In this position the appliance will operate
as a cold air fan.
Position 1: Low power heating.
.
2
Position 2: High power heating.
Turn the temperature selector (B) to the
maximum to switch the annexe on. Then
the light (C) will come on indicating that the
appliance is on.
5

4. ELECTRICAL CONNECTION

first time, make sure that the electrical
network voltage has the same value in V
(volts) as indicated on the characteristics
plate.
capacity for 10/16 amps.
CEE 89/336 directive relating to
electromagnetic compatibility.
5. OPERATION AND USE
: Summer service