Setting Up Your Cooktop - Dacor PREFERENCE RGC304 Use And Care Manual

Burner and Grate Assembly
WARNING
Assemble the burners and grates only when the cooktop
is cool.
SimmerSear Burner
1. Place the burner skirt over each SimmerSear
burner head and base as shown. On model
RGC365 be sure to match the correct size.
2. Put the burner cap on the burner head of each
SimmerSear burner as shown below. Center the
bottom of the cap inside the base. On model
RGC365 be sure to match the correct size.
3. Put the cap cover on top of each SimmerSear™
burner cap. The ridge around the bottom edge of
the cap cover goes around the top of the burner
cap. On model RGC365 be sure to match the
correct size.
SimmerSear Burner Assembly
*The burner head on the SimmerSear burner
assembly is permanently attached to the burner
base. It cannot be removed by the customer.

Setting Up Your Cooktop

Cap cover
Burner cap
Wide side
down!
Skirt
Burner head*
Base
Standard Burners
1. Put the burner heads on the burner bases as
shown below. Match the correct sizes. The
bottom of the correct size burner head fits on
top of the matching burner base. Line up the
notch on the bottom of each head with the
ignitor on the matching base.
2. Twist each head back and forth slightly to make
sure it is properly seated.
3. Put the cap covers on top of the burner heads.
The ridge around the bottom edge of the cap
cover goes around the top of the burner head.
Line up notch
with igniter
Notch Igniter
Standard Burner Assembly
Grates
Gently set the grates on top of the spill tray. Put the
legs of each grate into the corresponding dimples.
5
Cap cover
Burner head
Burner base