Warnings - EWM M3.7X-O Operating Instructions Manual

Rectifying faults

Warnings

Error 57: Slave tacho error
Category B
 Fault in the wire f eeder (slave drive).
Check the connections (connectors, lines).

 Permanent overload of the wire drive (slave drive).
Do not lay the liner in tight radii.

Check the liner f or ease of movement.

Error 58: Short circuit
Category B
 Short circuit in the welding circuit.
Eliminate the short circuit in the welding circuit.

Place the welding torch on an insulated surface.

Error 59: Incompatible machine
 A machine connected to the system is not compatible.
Disconnect the incompatible machine from the system.

Error 60: Incompatible software
 The sof tware of a machine is not compatible.
Disconnect the incompatible machine from the system

Request service.

Error 61: Welding monitoring
 The actual value of a welding parameter is outside the specified tolerance range.
Maintain the tolerance ranges.

Adjust the welding parameters.

Error 62: System component
 The system component was not found.
Request service.

Error 63: Mains voltage error
 Operating and mains voltage are incompatible.
Check or adjust the operating and mains voltage.

[1] See technical data for values and other switching thresholds.
7.3 Warnings
Depending on the display options of the machine display, a warning message is displayed as follows:
Display type - machine control
Graphic display
two 7-segment displays
one 7-segment display
The cause of the warning is indicated by a corresponding warning number (see table).
• In case of multiple warnings, these are displayed in sequence.
• Document machine warning and inform service personnel, if required.
Warning
1 Excess temperature
76
Display
Potential cause / remedy
A shutdown is imminent due to excess temperature.
099-5TLPXQ-EW501
15.12.2022