Programmed Recording Of A Cd - Aiwa XR-MR5 Operating Instructions Manual

PROGRAMMED RECORDING
OF A CD
Up to 30 tracks can be programmed and recorded from the loaded
CD. For programming, see page 15.
PUSH EJECTz
s
AUTO.F(RW)
MANUAL.F
CD
zCD-R/RW
OPEN/CLOSE
1 Load a CD-R or CD-RW in the CD-R/CD-RW player/
recorder.
Load the disc with the label side up. To open or close the disc
tray, press z CD-R/RW OPEN/CLOSE.
2 Press CD and load a CD to be recorded in the CD
player.
Press the PUSH EJECT z position to open the disc
compartment and load the disc with the label side up. Then
close the disc compartment.
Wait until the unit finishes reading the loaded discs. (Make
sure the "CD-R" or "CD-RW" indicator lights up, and the total
number of tracks and total playing time of the CD are displayed.)
3 In stop mode, press PROGRAM while pressing SHIFT
so that "PRGM" appears on the display.
4 Press the numbered buttons and +10 to program
a track.
Example:
To select the 12th track, press +10 and 2.
To select the 20th track, press +10, +10 and 0.
Selected track
number
Total number of
selected tracks
0-9,+10
PROGRAM
CD
s
MANUAL.F
AUTO.F
SHIFT
Program number
Total playing time of the
selected tracks
5 Repeat step 4 to program other tracks.
6 For manual finalizing recording, press
MANUAL.F on the main unit or on the remote
control.
For auto finalizing recording (only for a CD-RW),
press AUTO.F (RW) on the main unit or AUTO.F on
the remote control.
Recording stops automatically when the selected track finishes
playing.
When recording finishes, the "CD-R/RW REC" indicator disappears
in the display.
To stop recording before the end of the CD
Press s. Recording stops.
To stop play of the CD, press s again.
To record on a previously recorded CD-R or CD-RW
If there is an unrecorded section left on the CD-R or CD-RW, the
new recording automatically starts from where the previous
recording finished. If you want to start recording from the beginning
of a previously recorded CD-RW, erase the previous recording
completely. (See page 24.)
A finalized* CD-R or a finalized CD-RW, however, cannot be
recorded on.
* See "FINALIZATION" on page 23.
To change the display during recording
Press DISPLAY on the main unit or press DISPLAY while pressing
SHIFT on the remote control. (See page 31 for details.)
NOTE
You can change from auto finalizing recording to manual finalizing
by pressing MANUAL. F before recording is completed.
To do the opposite, similarly press AUTO.F (RW).
En
21
ENGLISH