Md Guide Messages - Aiwa XR-H66MD Operating Instructions Manual

MD GUIDE MESSAGES
Cause Solution
Message
Blank Disc
Can't Edit
Nothing is recorded on the disc,
See "THE LIMITATIONS OF MD" on page 22.
Disabled.
Tracks are too short to be joined.
The combine function was used while playing
back the first track.
The divide function was used at the beginning of
the track.
The combine function was used to join a track
recorded in monaural with a track recorded in
stereo.
Programmed play or random play is activated. Cancel the programmed play or random play.
No Disc
There is no disc loaded in the unit. Load a disc.
Replace the disc. The disc is damaged by scratches.
The unit received a strong shock during a TOC
reading.
There is not enough time remaining on the disc to
record.
Do not subject the unit to strong shock during a
TOC reading.
Disc Full Replace the
disc with another recordable disc.
Leave the unit in a cool place for a while before
operating it again.
Temp Over The temperature of the unit is too high.
Operate the unit at moderate room temperature.
The surrounding temperature is too high or too
low.
There is an attempt to record or edit a
prerecorded music disc (optical disc).
Replace the disc with a recordable one. PB Disc
Protected The disc is record-protected.
Slide the record-protect tab on the disc. (See
page 21.)
There is an attempt to record or edit a
prerecorded music disc (optical disc).
Replace the disc with a recordable one.
TOC
Futl
There are too many tracks or emphasis data to
be recorded or edited, or there is no room on the
disc.
Error occurs in the loading mechanism.
(All functions except the POWER
WIII
be
disabled.)
Erase tracks.
Mecha Err Turn the power off and disconnect the AC cord
once. Then turn it on again.
If this message still appears, consult your local
Aiwa dealer.
Emergency Recording is no longer possible because there
are scraches on the disc or the unit was
subjected to a strong shock during recording.
Recording is not possible due to SCMS (see
page 22).
Exchange the MD
Do not subject the unit to strong shock.
—
Check to be sure that the connected equipment is
playing, and that it is connected correctly to the
DIGITAL IN connector.
Contact an Aiwa service representatwe.
Exchange the MD.
Do not subject this unit to strong shock during
recording, or during recording or reading of the
TOC.
Erase ail tracks on the MD with this error, and you
can use this MD as a blank disc again.
Load the MD correctly (see page 11).
You can press the CD-1 MD button again to
record (even through there is not enough
recordable time).
Can't Copy
No Signal No singals are being input from the connected
equipment to the DIGITAL IN connector.
An error occurred in the MD unit of this unit.
An error occurred in the TOC of the MD because
this unit was subjected to a strong shock during
recording, or during recording or reading of the
TOC.
An MD was loaded incorrectly.
There is not enough recordable time on the MD,
(This appears only when the CD-1 MD button
has been pressed.)
MD Error
UTOC Err
Load Check
TIME OVER
39
ENGLISH