Troubleshooting Guide - Aiwa XR-H66MD Operating Instructions Manual

TROUBLESHOOTING GUIDE
If
the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
Is the AC cord connected properly?
Is there a bad connection? (+ page 3)
There may be a short circuit in the speaker terminals.
+ Disconnect the AC cord, then correct the speaker
connections.
Was an incorrect function button pressed?
Sound is emitted from one speaker only.
Is the other speaker disconnected?
The output sound is not stereo.
Is the Karaoke function turned on? (+page 28)
An erroneous display or a malfunction occurs.
+ Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
Is the antenna connected properly? (+ page 4)
Is the signal weak?
+ Connect an outdoor antenna.
The reception contains noise interferences or the sound is
distorted.
1sthe system picking up external noise or multipath distortion?
~ Change the orientation of the antenna.
+ Move the unit away from other electrical appliances.
CD PLAYER SECTION
The CD player does not play,
Is the disc correctly inserted? (~ page 9)
[s the disc dirty? (~ page 36)
Is the lens affected by condensation?
+ Wait approximately one hour and try again.
To reset
MD RECORDER SECTION
The MD recorder can not be operated
Is
there a disc inside the unit?
+ Insert a disc.
Is the lens affected by condensation?
+ Wait approximately one hour and try again,
Sound is noisy
Is the unit placed close to an object with a strong magnet
field such as a television?
+ Move the unit away from the television.
Sound is intermittent
Is the unit placed on an unstable surface with a lot of vlbratlo
+ Place the unit on a stable surface with no vibration.
Recording is not possible
Is the CD F IMD, 3CD 3MD or CD SINGLE IMD butt
pressed when attempting to record from a source other than a ~sz
w;>. ti;;\ . ...,, . ...>..
j<, ,}2 ,<, ,*:
CD7
Is a prerecorded disc inserted?
A Change to a recordable disc.
1s the disc protected by the record-protected tab on the disc?
(+ page 21 )
If an unusual condition occurs in the display window, reset the
unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER button to turn the power back on while
pressing the CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2.
ENGLISH
38