Fagor 2F2611 User's Installation And Operation Manual page 6

4
ELECTRICAL CONNECTION
Consult the characteris-
tics panel situated on
the porthole door of the
washing machine before
making the electrical
connections. Ensure that
the voltage available at
the base of the socket is
the same as the voltage
indicated on the panel.
Do not remove the
characteristics panel.
It contains important
information.
5
PANELLING
It is easy
to change the coating
of the washing
machine panels
to match your kitchen
furniture. These coa-
ting panels may
not be thicker than 5
mm.
a Loosen the
screws of the hin-
ges and dismantle
the door of
the washing
machine.
b Remove the lower
protection frame,
loosening the
screws.
Extract the panel
that was supplied
with the washing
machine.
IMPORTANT
It is very important to earth the washing machine properly.
The electrical fittings, socket, plug, fuses or automatic
switch and meter must be scaled for the maximum power
indicated on the characteristics panel.
If the power cord is damaged, it must be replaced by one
with the same reference number, only available from an
authorised service centre.
On built-in washing machines, the mains plug must be
accessible after installation.
c If the new panel is 3
mm. thick or more,
you will not need to
leave the original
panel. If it is less than
3 mm. thick, place it
over the panel origi-
nally supplied with the
washing machine.
a
c
In order to assemble the
door with the new decora-
tive panel, repeat the steps
given in points a, b, c.
b