Configure Snmp Trap - D-Link DES-1226G Owner's Manual

Delete Group: To delete previously defined SNMP Community group, press "Delete Group" button, the Delete SNMP Community configuration window
will pop out; checked the delete dialog box. Press "Apply" to delete the selected SNMP Community Group.
Modify Group: To modify previously defined SNMP Community group, click on the ID parameter to enter to the selected SNMP Community Group to
configure its community name and community enable. Press "Apply" to save change of the SNMP Community Group.

Configure SNMP Trap:

Trap authentication fail: When checked the dialog box of the Trap authentication fail, when fail to authentication, the Switch will trap the authentication
fail even to the SNMP host.
Add Trap: To create a recipient of SNMP traps generated by the Switch's SNMP agent, press "Add Trap" button, and the SNMP Trap Set window will pop
out; you can fill in the community name and trap IP address of the remote management station that will serve as the SNMP host for the Switch and checked
the events selection n to enabled selected event traps.
Figure 24. Add SNMP Community group
Figure 25. Delete SNMP Community group
Figure 196. Modify SNMP Community group
Figure 27. Configure SNMP Trap Setting
Figure 28. Add SNMP Trap
16