Table of Contents
Advertisement
Connections
Front Panel
└──────┘
LEDIndicators
10/100BASE-TX Twisted-Pair Ports (Port1~24)
These ports support network speeds of either 10Mbps or 100Mbps, and can operate in half- and full- duplex
transfer modes. These ports also support automatic MDI/MDI-X crossover detection, giving true "plug and play"
capability. Just plug the network cable directly into the hub; you can use either straight-through or crossover
cable.
10/100/1000BASE-T Twisted Pair Ports (Port 25~26)
The DES-1226G is equipped with two Gigabit twisted pair ports that are auto negotiable 10/100/1000Mbps and
also support auto MDI/MDIX crossover detection. These two ports can operate in half- and full- duplex modes.
SFP(Mini GBIC) Ports (Option Port 25~26)
The Switch is equipped with two SFP(Mini GBIC) ports, supported optional 1000BASE-X SFP(Mini GBIC)
module.
Note: When the port is set to "Forced Mode", the Auto MDI/MDIX will be disabled.
Rear Panel
AC Power Connector
This is a three-pronged connector that supports the power cord. Plug in the female connector of the provided
power cord into this connector, and the male into a power outlet. Supported input voltages range from 100~240V
AC at 50~60Hz.
Reset
The Reset button is to reset all the settings back to the factory defaults.
Note: Be sure that you record the settings of your device, or else all settings will be erased when pressing the
"Reset" button.
10/100 Base-TX Twisted-Pair Ports
┌────────────────┐
Figure 2. Front Panel
●
Reset
button
Figure 3. Rear Panel
6
SFP(Mini GBIC) Ports
┌───┐
└───┘
10/100/1000Base-T
Twisted-Pair Ports
Advertisement
Table of Contents
