For ford super duty f-250 / f-350 regular cab, ford super duty f-250 / f-350 super cab, ford super duty f-250 / f-350 crew cab 1999-2001/2004-2007 and ford excursion 2000-2001/2004-2005 (10 pages)
Chevrolet silverado1500 / gmc sierra 1500 - double cab/ chevrolet silverado1500 / gmc sierra 1500- crew cab 2014-18, chevrolet silverado hd / gmc sierra hd - double cab / chevrolet silverado hd / gmc sierra hd- crew cab 2015-19 (13 pages)
A M P R E S E A R C H P O W E R S T E P – F O R D F - 1 5 0 S U P E R C R E W INSTALLATION GUIDE Attaching motor to linkage assembly The motors need to be installed before continuing with the rest of the Power Step install.
Page 3
A M P R E S E A R C H P O W E R S T E P – F O R D F - 1 5 0 S U P E R C R E W (A) End cap left (x1) (B) End cap right (x1) (C) T-nut insert (x2) (D) Socket cap screw (x2)
Page 4
A M P R E S E A R C H P O W E R S T E P – F O R D F - 1 5 0 S U P E R C R E W PARTS LIST AND HARDWARE IDENTIFICATION Rear Bracket Front Bracket Rear Bracket...
Page 5
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W Install U-Nut. Drilling Forward Mounting Holes: Install U-Nut.
Page 6
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W Line up T-nuts of step extrusion and insert 1/4-20 The rearward edge of the board should be bolts.
Page 7
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W Pierce holes in front floor board grommets to allow Route harness end with motor connectors access for harness trigger wire into cab of vehicle.
Page 8
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W Remove driver side step plate and kick panel. Of the Locate harness bundle under driver sill plate, open three connectors to the left of the parking brake pedal, bundle and find Black with Light Blue stripe wire.
Page 9
Under passenger front kick panel locate bundle that Connect purple trigger wire to Double Diode Harness. comes from the rear of the vehicle. Open the bundle and Connect one open end of the harness to the red locate the Black with White stripe wire and splice in connecting wire from the door and the other end to Single Diode Harness with the diode end toward the front the blue butt connector of step 25.
A M P R E S E A R C H P O W E R S T E P – F O R D F - 1 5 0 S U P E R C R E W Check that all doors activate the Power Step and the LED Lights work when doors open and close. Reinstall any remaining trim panels.
5-YEAR LIMITED WARRANTY AMP RESEARCH warrants this product to be free from defects in material and workmanship for FIVE (5) YEARS FROM DATE OF PURCHASE, provided there has been normal use and proper maintenance. This warranty applies to the original purchaser only.
Need help?
Do you have a question about the PowerStep 75111-01A and is the answer not in the manual?
Questions and answers