Device Installation - PAX IM30 Product Manual

The M4 stud bolts should extrude from the back of the mounting plate to allow for the mounting bracket
to slot into place.

3.4 Device Installation

Installing the mounting bracket
The first step to installing the IM30 as part of an unattended payment terminal is to secure the mounting
bracket onto the mounting plate. The back of the mounting plate should have four M4 stud bolts that
correspond to the four outer mounting points on the mounting bracket. Slid the mounting bracket onto
the four bolts with its as illustrated in Figure 30: attaching the mounting bracket to the mounting plate,
then use four M4 nuts to secure it in place.
PAX TECHNOLOGY LIMITED Page 30 of 35 Product Manual