Advertisement
Quick Links
FENDER FLARE
PLEASE READ AND FOLLOW THIS APPROVED INSTRUCTION CARE-
FULLY BEFORE INSTALLATION. FAILURE TO DO SO MAY CAUSE
DAMAGE TO THE VEHICLE AND WILL INVALIDATE THE WARRANTY.
PRIOR TO INSTALLATION
• Remove contents from box. Verify all parts are present and free
from any defects or damage.
• Make sure installation is done on a non-abrasive surface to avoid
scratching the flare surface.
• Pre-fit each flare to the vehicle body to ensure they suit the
profile of the vehicle.
• Remove existing decals and mud flaps on the vehicle that may
interfere with flare installation.
• Make sure all flares and fender wheel well are clean as the
presence of dirt or sand may scratch auto body paint.
• Suggest removing the tire before installation for easier access.
• Do not use any harsh abrasive detergent to clean the flare.
PAINTING
Painted flares cannot be returned. Test fit before painting. We are
not responsible for any costs that may incur if flares were painted
without test fitting.
• Clean surface to be painted with a mild detergent or grease
remover. Do not use lacquer thinner or any solvent based product.
• To achieve best result, wipe flare surface to be painted com-
pletely dry with a tack rag prior to paint.
• Use high quality polyurethane automotive paint to paint the
flares. Application of primer may be needed. Please see paint
manufacturer's specifications.
• Not recommend to paint the edge trim, but if desired, use a flex
additive.
WARNING
Dirt or debris may become lodged between flares and vehicle's
fenders causing scratching and paint wear from vehicle vibration.
TYGER is not responsible for any damage, and installation is done
with buyer's understanding that this damage may potentially
occur.
SAFETY INFORMATION
• Before driving, ensure that flare is properly secured to vehicle.
• Do not use automatic "brush-style" car wash.
• Periodically check all components for tightness.
TG-FF8C4057
Customer Support: www.TygerAuto.com/Contact
1/4
Customer Support 1-866-340-3038
Tools Required
Hardware Included
x1
x40
[A]
[B]
x1
x22
[E]
[F]
DAMAGED or MISSING PARTS?
www.TygerAuto.com/Contact
TM
x40
x40
[C]
[D]
x1
[G]
Advertisement
Related Manuals for Tyger TG-FF8C4057
Summary of Contents for Tyger TG-FF8C4057
- Page 1 WARNING Dirt or debris may become lodged between flares and vehicle's fenders causing scratching and paint wear from vehicle vibration. TYGER is not responsible for any damage, and installation is done with buyer's understanding that this damage may potentially occur.
- Page 2 EDGE TRIM INSTALLATION • Peel 2 inches of red backing away from one end of Edge Trim [A] . • Apply Edge Trim over top edge of flare with adhesive side contacting inside edge of flare. • Press Edge Trim into place and apply thumb pressure to ensure good adhesion, pull away red backing as you work your way around flare edge in one-foot increments.
- Page 3 Driver Side Flare Installation STEP 1: Position front flare in place by aligning up holes in flare with STEP 2: Insert the supplied Tuflok [F] through holes in flare and into vehicle's eisting factory holes. Starting at the top center, install 6 vehicle's factory holes.
- Page 4 Customer Support: www.TygerAuto.com/Contact...
Need help?
Do you have a question about the TG-FF8C4057 and is the answer not in the manual?
Questions and answers