Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Intertec Data Systems CP FLATTHERM D.A HI
Summary of Contents for Intertec Data Systems CP FLATTHERM D.A HI
- Page 1 Operating Instructions CP FLATTHERM D.A HI HOM499335051en-7 • 11/06/2024...
-
Page 2: Table Of Contents
www.intertec.info Table of contents 1 General .................................. 3 2 Use................................... 3 3 Specific conditions for use ........................... 3 4 Explanation of symbols for warnings and signal words .................. 3 5 Safety information.............................. 4 6 Technical Data ................................ 4 7 Installation ................................ 4 8 Connection................................ -
Page 3: General
Operating Instructions CP FLATTHERM D.A HI 1. The connecting lead shall be installed to provide for General permanent wiring and adequate protection against These operating instructions describe the safe and mechanical damage. proper way to work with the device. The safety 2. -
Page 4: Safety Information
Operating Instructions CP FLATTHERM D.A HI Switching capacity of fault 10 A / 275 V AC NOTICE alarm (AM) Connecting cable Silicone hose cable, NOTE notch- and oil resistant, 3 It is essential to pay attention to this safety advice as you x 1,5 mm²... - Page 5 Operating Instructions CP FLATTHERM D.A HI The connection cable must be permanently installed up NOTICE to the inlet into the on-site junction box, taking the permissible bending radius = 5 x outer diameter into Carefully remove consideration. When removing from the packaging and during...
-
Page 6: Connection
Operating Instructions CP FLATTHERM D.A HI Connection INFO Ground The device may only be connected up and secured by a RS 485 trained person, taking into account the "rated voltage" TC DIGITAL and "rated current" specified on the nameplate. - Page 7 Operating Instructions CP FLATTHERM D.A HI If the heater fails, check the installation. Carry out a CAUTION continuity test on the heating circuit. Pay attention to the connection diagram switching point Sufficient heat dissipation must be ensured. thermostat! Unauthorized covers must be removed as otherwise In the case of overheating, the thermal indicator (see there is the risk of the heater overheating.
- Page 8 Operating Instructions CP FLATTHERM D.A HI Further information and service NOTICE If the information contained in this instruction manual Environmental damage may be caused if should not be sufficient in any way, then INTERTEC would be glad to be at your disposal to provide further disposed of incorrectly! information and service.
Need help?
Do you have a question about the CP FLATTHERM D.A HI and is the answer not in the manual?
Questions and answers