Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Intertec Data Systems CP MULTITHERM D.A HI
Summary of Contents for Intertec Data Systems CP MULTITHERM D.A HI
- Page 1 Operating Instructions CP MULTITHERM D.A HI HOM161009163Ien-1 • 01/06/2017...
-
Page 2: Table Of Contents
www.intertec.info Table of contents 1 General .................................. 3 2 Use ................................... 3 3 Explanation of symbols for warnings and signal words .................. 3 4 Safety information .............................. 3 5 Installation accessories ............................ 4 6 Technical Data ................................ 4 7 Installation................................ 4 8 Connection................................ -
Page 3: General
Operating Instructions CP MULTITHERM D.A HI Safety information can be found at the start of the General chapter before the instructions which may lead to a haz- These operating instructions describe the safe and ardous situation. Additional safety information can be proper way to work with the device. -
Page 4: Installation Accessories
Operating Instructions CP MULTITHERM D.A HI Protection class IP66/IP68 1bar/30min CAUTION Rated voltage max. 250 V AC Permitted operating voltage max. 275 V AC Risk of burns from a hot surface Rated current (in compli- max. 10 A Attainable highest temperatures: ance with VDE 0298) - Max. -
Page 5: Connection
Operating Instructions CP MULTITHERM D.A HI NOTICE Carefully remove When removing from the packaging and during trans- port, the connection line must not be stressed or bent. For free convection, the heater needs to be installed with ribs standing vertically. The minimum distances to the floor and to devices above it must be complied with. -
Page 6: Commissioning
Operating Instructions CP MULTITHERM D.A HI In a TT or TN system, a residual current device (RCD) must be used where the measured triggering residual current does not exceed 100 mA. Residual current devices with a measured triggering residual current of 30 Ground mA are preferable. -
Page 7: 14 Ec Declaration Of Conformity
Operating Instructions CP MULTITHERM D.A HI Repairs may only be carried out by the manufacturer in NOTICE the factory. In the dust Ex area, the applicable requirements of EN Environmental damage may be caused if dis- 60079-17 and EN 60079-19 must be complied with. -
Page 8: 15 Further Information And Service
Operating Instructions CP MULTITHERM D.A HI Further information and service If the information contained in this instruction manual should not be sufficient in any way, then INTERTEC would be glad to be at your disposal to provide further in- formation and service.