Page 5
Emergency Stop ..................360° Flip ....................Altitude-Hold Function ............... Headless Mode ..................Attitude Adjustment Trimmer ....................Calibrate the Gyro................. Specification ....................Contact Us ..................... General Information ...................
Any personal injury, property damage, legal disputes and all other adverse events caused by the violation of any of the safety instructions or due to any other factor, WILL NOT be DEERC’s responsi- bility. SAFETY GUIDELINES CHECK BEFORE USE ①...
Page 7
SAFETY GUIDELINES ④ Please perform a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear off on the propellers, battery power and effectiveness of the indicator, etc. If there is any problem found after checking the drone, please refrain from using it until the problem is resolved.
Page 8
SAFETY GUIDELINES OPERATION REQUIREMENTS ① DO NOT use this product to follow any moving vehicles. ② During the flight, turn off the motors only in case of an emergency. ③ When the battery runs low, return the drone back to your starting point.
Page 9
SAFETY GUIDELINES ⑦ Only use the USB charging cable that comes with the drone to charge the battery. ⑧ DO NOT connect the battery directly to wall outlets or car cigarette -lighter sockets as this will damage your battery since they have different voltages.
MAINTENANCE ① Clean the drone after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. ③ This device is not waterproof and must not be submerged or subjected to water under any circumstance.
JOYSTICK MODE MODE 2 (Left hand throttle MODE 2 will be the default setting.) Left Joystick Right Joystick Ascend Forward Descend Down Down Backward Left Right Left Right Fly to Fly to Rotate Rotate Left Right Left Right MODE 1 To enter MODE 1, turn on the transmitter while holding the “Speed Switch/Trimmer”...
PREPARATION BEFORE FLIGHT CHARGING USB Adapter (5V/1A) Power Bank ① Connect the the drone's battery with the USB Charging Cable. ② Plug the USB Charging Cable into a USB charging port on the power bank or USB adapter (5V/1A). ③ Charging time: about 70 minutes. ④...
PREPARATION BEFORE FLIGHT DOWNLOAD APP Android APP on Google Play Scan the corresponding QR code and download the Deerc FPV app for free. Required Operating Systems: iOS 12.0 or later/Android 5.0 or later. ARMS All arms of the drone are folded before the drone is packaged at the factory.
PREPARATION BEFORE FLIGHT DRONE BATTERY Installation: Push the battery into the battery compartment at the rear of the drone. Make sure that you hear a click sound, which indicates that the battery is firmly installed. The battery should be installed firmly. Otherwise, the flight safety of your drone may be affected.
PREPARATION BEFORE FLIGHT PROPELLERS HEAD Installation: ① An “A” “B” is printed on the back of each propeller. ② Lock the propellers to the corresponding motor shafts (the motor shafts are also marked) with a screw. ③ Rotate each screw clockwise. - The propeller is installed before the drone is packaged at the factory.
PREPARATION BEFORE FLIGHT PHONE HOLDER ① Remove the dust cover. ② Insert the phone holder into a slot on the top of the transmitter. ③ The phone holder can be adjusted to an angle you like. ④ Open the phone holder and put your phone in. -14-...
FLIGHT All of the following operations in this manual use MODE 2. * If you first pair the drone with the transmitter, then with the cellphone, certain app functions will not work. Conversely, if you use the analog control sticks in the app to control the drone's movements first, you cannot pair the drone with the transmitter then.
CONNECT TO WI-FI Connect your phone to the Wi-Fi network created by the drone. You can check the drone’s status on the Deerc FPV App. ① Make sure to turn off Bluetooth, Mobile Data, and VPN. Enter your phone’s Wi-Fi settings and click Wi-Fi to search for the Wi-Fi of the drone.
FLIGHT ONE KEY TAKEOFF/LANDING ① Unlock: Short press the ( ) button to unlock the motors. ② Takeoff: Short press the same button again, the drone will automati- cally take off and hover at 4 ft. At this time, you can control this drone by using the joysticks.
FUNCTIONS DETAILS TAKE PHOTO/RECORD VIDEO Take Photo: Short press the ( ) button on the transmitter to take pictures. The transmitter will beep once, and the drone’s indicator will flash once. This indicates that the camera has successfully taken a picture.
FUNCTIONS DETAILS HIGH-SPEED ROTATION Short Press Short press the ( ) button, the transmitter will beep once, the drone begins to rotate quickly. The drone will exit the High-Speed Rotation function automatically after 10 seconds, or you can also push the right joystick in any direction to stop the rotation.
FUNCTIONS DETAILS SPEED SWITCH Short Press Short Press This drone comes with 3 speed modes (Low/Medium/High). Short press the ( ) button to switch between low, medium, and high speed. The transmitter beeps once to indicate Low Speed, beeps twice to indicate Medium Speed and beeps three times to indicate High Speed.
FUNCTIONS DETAILS 360° FLIP 10 ft When you get familiar with all the functions of the drone, you can try this amazing flip mode. When the drone is at least 10ft from the ground. Press down on the right joystick, then push the right joystick forward/backward or leftward/rightward.
FUNCTIONS DETAILS HEADLESS MODE The Headless Mode is a great training tool for beginner pilots. It is also useful when the drone is too far from the pilot (which makes it difficult to tell its orientation). It keeps the drone traveling forward, backward, left, or right when you move the right joystick in those directions, regardless of which way the front of the head of the drone points to.
Page 28
FUNCTIONS DETAILS * Why is the orientation of the drone important? In normal flying mode, the control of the drone movement can sometimes be counter-intuitive for beginners. For instance, when the drone is in the air with its head pointing to your right, if you push the right joystick forward, the drone will fly to your right, instead of flying forward.
ATTITUDE ADJUSTMENT TRIMMER The Forward Trim If the drone tends to drift forward: 1. Press down the ( ) button and do not release it. 2. At the same time, push the right joystick backward one time. 3. Depending on how the drone drifts, it may take several pushes to balance the drone.
ATTITUDE ADJUSTMENT CALIBRATE THE GYRO Long Press Make sure to place the drone on a level surface before calibrating the gyro. Long press the Gyro Calibration button for 2 Seconds to calibrate the gyro. The transmitter will send out a long beep which indicates the calibration is completed.
Input: 5V/1A Rated Power: ≤5 W CONTACT US Please do not hesitate to contact us if you need further support. 4:00 PM ~ 7:00 AM (PST) usa@deerc.com (USA) eu@deerc.com (EU) +1(855)777-8866 For online support, please scan this code with Live Chat.
The Supplier's Declaration of Conformity is available at the following address: https://www.deerc.com/Download/US/D70_FCC_sDoC.pdf. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 34
GENERAL INFORMATION WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with minimum distance 20cm between the radiator &...
Page 35
GENERAL INFORMATION CAN NMB-003 (B) RF Exposure Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Page 36
GENERAL INFORMATION BATTERY WARNING: 1. Failure to follow all the instructions may result in serious injury, irreparable damage to the battery may cause a fire, smoke or explosion as well. 2. Always check the battery’s condition before charging or using it. 3.
Page 37
GENERAL INFORMATION 13. Batteries MUST be inserted with the correct polarity. 14. The supply terminals MUST not to be short-circuited. Regular examination of transformer or battery charger for any damage to their cords, plugs, enclosures and other parts MUST be done. If there is damage, they MUST not be used until the damage has been repaired.
Page 38
Directive 2009/48/EC have been fully fulfilled on our product with indication below: Product Name: Remote control four axis series Model/Mark: D70/DEERC The Statement of compliance is available at the following address: http://www.deerc.com/Download/CE/D70_EU_DOC.pdf This product can be used among EU member states.
Need help?
Do you have a question about the D70A and is the answer not in the manual?
Questions and answers