KI CrossRoads Shelving Assembly Instructions

Figure 1
Figure 2
1330 Bellevue Street • P .O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2008 KI All Rights Reserved • Litho in USA. • Code KI-61562BR4-MBS/TMI/GT/1209
Assembly Instructions
CrossRoads
Double Face Metal with Back Stop
Double Top Assembly
2" Hex Head Bolts
with Lock Washers
and Flat Washers (4)
Peg Holes
Figure 1
Double Shelf.eps
Base Assemblies
Figure 2
Double Base Asm.eps
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must
be tightened securely and must be checked periodically
after assembly. Failure to assemble properly, or to secure
parts may result in assembly failure and injury.
® Shelving
December 2009
End Panel
Glides (2)
End Panel
Tools Required:
• #2 Phillips screwdriver
• 1 / " socket
2
• Socket wrench
Hardware Included:
• #8 x 5 / " screws
8
• #8 x 1 1 / " screws
4
• 5 / " x 2" hex head bolt
16
• 5 / " x 4 1 / " hex head bolt
16 2
• / " flat washer
1
4
• 5 / " lock washer
16
• 5 / " flat washer
16
• 5 / " hex nut
16
• Metal pegs
1. Set one end panel on flat surface with
the peg holes up.
2. Position the double top assembly,
routed side down on end panel. Align
the pre-drilled holes with the inserts.
Fasten with 5 / " x 2" hex head bolts
16
and washers (Figure 1). Note: for
shelving units 72" and higher, the top
shelf assembly should be flipped so
that the cleat side faces up.
3. Position the base assemblies by
aligning the holes so that the bottoms
of the base assembly facings are flush
with the bottom of the end panel.
Fasten with 2" hex head bolts and
washers (Figure 2).