KI All Terrain Modular Storage Tower Assembly Instructions

Figure 1
black plastic
screw cap
4mm x 10mm
screw
flush-mount pull
Figure 2
1330 Bellevue Street • P. O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2004 KI All Rights Reserved • Litho in USA • Code KI-61327R1/KI/GT/804
A s s e m b l y I n s t r u c t i o n s
M o d u l a r S t o r a g e T o w e r
storage tower
1 / -20 x 5 /
4 8
front
hex bolt
locking caster
non-locking
caster
/ -20 x / "
1 5
4 8
hex bolt
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
A l l Te r r a i n
®
A u g u s t 2 0 0 4
"
Part # 2.80483

Caster Assembly

1. Locate the caster/hardware
packet that is shipped inside the
storage tower. Secure or remove
any loose components from
inside the cabinet.
2. Carefully turn the storage tower
on it's back as illustrated on a
soft protective surface.
3. Position the casters as illustrated
with the locking casters to the
front of the storage tower. Secure
each caster to the underside of
the tower with four 1 / -20 x 5 / "
4 8
hex head bolts (Figure 1).
4. Gently raise the cabinet to it's
upright position onto the casters
(Figure 1).

Flush-Mount Pull Assembly

1. Locate the pull/hardware packet
that is shipped inside the storage
tower.
2. Using two 4mm x 10mm screws,
fasten the pull to the door as
illustrated (Figure 2).
3. Finish the inside of the door with
two black plastic screw caps
(Figure 2).
Note: If installing a pull on a
laminate door, use two 4mm x
25mm screws per pull. Black
caps are not required.