Dover HEIL Command-SST Operation And Service Manual page 40

Voltage of Electric Line
Above 750,000 to 1,000,000
LOADING REFUSE INTO THE UNIT
YOU MUST BE ATTENTIVE at all times when you load refuse and be ready to stop or reverse the function in use if
necessary.
ALL PERSONS MUST STAND CLEAR when the tailgate is in motion and during the unloading cycle. MAKE SURE
no one stands under or crosses under a raised tailgate.
LOOK UP AND LIVE. Make sure there is enough clearance between a raised container and overhead power lines.
Refer to Tables 1 and 2.
UNLOADING
MAKE SURE the unloading area is clear of all personnel.
ALL PERSONS MUST STAND CLEAR when the tailgate is in motion and during the unloading cycle. MAKE SURE
no one stands under or crosses under a raised tailgate.
While you raise the body, be attentive at all times and be ready to stop or reverse the function if necessary.
WHEN WORKING IN OR AROUND THE VEHICLE
MAKE SURE the unit is in Lock-Out/Tag-Out condition BEFORE you work in or around the unit.
NEVER put any part of your body between a raised body and the chassis frame unless the frame is securely
propped up. Read and follow the instructions for Propping the Body
DO NOT go under the chassis or enter the body area unless the unit is locked-out. To lock-out the unit, stop the
engine, apply the brakes and make sure the brakes hold and work properly, chock all wheels, remove the keys from
the cab, and place a lock-out tag on the steering wheel. See Lock-Out/Tag-Out Procedure.
Issued June 2020
Safety Messages and Decals
Table 2. Overhead Clearances When Driving the Unit
Minimum Clearance
20 feet (6.1 m)
.
77
Copyright 2020, Heil Environmental
Printed in U.S.A.
30