DeFelsko PosiTector Dew Point Meter Logger Plus Instruction Manual page 5

Configuring WiFi using the PosiTector App
The PosiTector DPM L+ features WiFi, allowing the probe to
automatically sync datasets to PosiSoft.net: the free to use,
cloud-based storage service. WiFi settings are configured using
the PosiTector App, while connected to the probe via Bluetooth.
WiFi Info
View information on the current WiFi settings, including network
name and the status of the most recent sync to PosiSoft.net.
WiFi Settings
When WiFi is toggled ON, the PosiTector DPM L+ scans for
available WiFi networks, and a list is displayed in the PosiTector
App. Select a network from the list, enter the passcode, and
select OK.
Once WiFi has been configured, the PosiTector DPM L+ will
perform a Network Connection Test. During the test, the
PosiTector DPM L+ will disconnect from the PosiTector App.
Within 30 seconds, the probe will reappear on the list of
available probes. Select the probe from the list and ensure the
Last Sync Successful icon
will be synced to PosiSoft.net whenever the power button is
pressed, or automatically at the set sync interval when in
Logging Mode. If the Last Sync Unsuccessful icon
displayed, the WiFi password may be incorrect, a firewall may
be preventing connection with PosiSoft.net, or the WiFi signal
may be too weak.
NOTE:
The Last Sync Successful icon
recent WiFi Check was successful. If moving the PosiTector
DPM L+ to a new location, use WiFi Check (pg. 5) to update the
status of the icon to ensure connectivity.
Toggle WiFi OFF, and press OK to disable WiFi.
When DHCP is toggled on (default), the probe will automatically
be assigned an IP address according to the Dynamic Host
Configuration Protocol. To manually assign an IP address, toggle
DHCP off.
See your network administrator or IT department for additional
assistance.
is displayed. All stored readings
4
is
shows if the most