TR OUBLE SHO OTING & ER R OR CODE S
ERROR CODES
ERROR CODE
MEANING
E01
Fail to connect Lower Control Board
with console
E02
Frequency converter overcurrent
E03
Converter overheating
E04
Incline Motor Error
E05
Converter bus voltage
less than 220V (2 mins)
E06
Converter output short circuit
E07
Converter bus voltage
is over 390V (0.1 second)
E08
Converter bus voltage
is over 380V (10 seconds)
18
ECHELON FITNE S S |
S TRIDE- 8 S
SOLUTION
1. Check whether a connector is loose, or whether the wire is
damaged or matched.
2. The lower control board may be defective. Check and replace
the lower control board.
3. If the console is damaged, test whether it is damaged before
replacement.
1. Wait 20 seconds after power off, then turn on electricity.
2. Check whether the roller bearing is in fault, and whether the
running deck and running belt are under lubricated.
3. Replace the lower control board.
1. Wait 20 seconds after power off, then turn on electricity.
2. Check whether the motor compartment components are dusty
and whether the fan is faulty.
3. Replace the frequency converter.
1. E4 error is automatically cleared after the incline calibration
is performed
2. Check whether inclination is inserted properly and whether it
is in fault.
3. Replace the lower control board.
1. Wait 20 seconds after power off, then turn on electricity.
2. Check whether the power supply voltage is low.
3. Replace the lower control board.
1. Check whether the converter output connection is correct.
2. Check the motor for damage.
3. Replace the frequency converter.
1. Wait 20 seconds after power off, then turn on electricity.
2. Check whether the power supply voltage is high.
3. Replace the lower control board.
1. Wait 20 seconds after power off, then turn on electricity.
2. Check whether the power supply voltage is high.
3. Replace the lower control board.
Questions or Concerns
Our members are our priority! If you require assistance or
have concerns, please contact our customer service team.
(833) 937-2453
cs@echelonfit.com
Submit a Request:
Warranty Information
Your Echelon Stride-8s treadmill comes with a 1-year parts
and labor warranty. Should the need arise, all you need
is a proof of purchase and our customer service team
will be happy to assist. Additional 1- or 2-year extended
warranties are available through customer service.
INS TRUC TION M A NUA L
19
Need help?
Do you have a question about the STRIDE-8s and is the answer not in the manual?