Advertisement
Advertisement
Table of Contents
Related Manuals for ShowPro Blinder II
Summary of Contents for ShowPro Blinder II
- Page 1 Blinder II USER MANUAL LEDNIT230...
-
Page 2: General Instructions
WARNING! Before carrying out any operations with the unit, carefully read this instruction manual and keep it with cure for future reference. It contains important information about the installation, usage, and maintenance of the unit. SAFETY General instructions • The products referred to in this manual conform to the European Community Directives and are therefore marked with CE. -
Page 3: Specifications
INTRODUCTION Blinder II is a warm white LED audience blinder with a modern design and advanced features designed to reproduce the look and feel of the classic incandescent effect. Features 2 x 100w warm white LEDs, driven by 78w per source... - Page 4 OVERVIEW...
-
Page 5: Basic Functions And Operation
DIMENSIONS BASIC FUNCTIONS AND OPERATION DOWN MENU ENTER Increase the displayed Decrease the displayed Display main menu, or Confirm displayed value, or scroll thru value, or scroll thru return to higher menu values, or activate previous menu items next menu items levels displayed functions, or enter submenus, or... - Page 6 Notice This product is only suitable for indoor use, with a protection level of IP20. The lighting fixtures should be kept clean and use should be avoided in damp or dusty environments. Maintenance should be carried out every three months. Qualified professionals are only allowed to install, operate, and maintain lighting fixtures, and ensure strict adherence to the procedures described in this manual.
-
Page 7: Dmx Charts
Display backlight always on Display backlight off after 10 seconds of inactivity Back Light Display backlight off after 20 seconds of inactivity Display backlight off after 30 seconds of inactivity Fixture Hours Shows usage hours Information Version Shows firmware version Factory Reset Reload default factory settings DMX CHARTS... -
Page 8: Maintenance And Cleaning The Unit
MAINTENANCE Maintenance and cleaning the unit • Make sure the area below the installation place is free from unwanted persons during setup. • Switch off the unit, unplug the main cable and wait until the unit has cooled down. • All screws used for installing the device and any of its parts should be tightly fastened and should not be corroded. - Page 9 OPTIONAL MASTER BRACKET ASSEMBLY ILLUSTRATION...
Need help?
Do you have a question about the Blinder II and is the answer not in the manual?
Questions and answers