Wali M002-32 Installation Manual

INSTALLATION MANUAL
Dual Monitor Desk Mount
M002-32
Supplied Parts List
Pole C-Clamp
a (x1) b (x1)
M4x30 Bolt M4 Spacer
k (x8) l (x8)
1
Option A : Clamp Installation
1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and a c
tighten with Allen Key 3mm o .
i
c
o
Stick the EVA pad B o to
the C-Clamp Brace c c
f
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
C-Clamp Brace Arm
c (x1) d (x1)
M10 Hand Knob EVA Pad A
m (x1) n (x1)
2. Remove the screw, washer and top plate from the M10 Hand Knob m , then connect the M10 Hand
Knob m and C-clamp b with the screw, washer and top plate that were just removed.
m b
f
Select the preferred height according to your desk thickness. Connect C-clamp b to C-clamp Brace c
using M8x12 Bolt g , and tighten with Allen Key 5mm i . Rotate the Hand Knob m clockwise to fasten g
for stability.
a
c
m
i
3mm
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
VESA Plate M5x14 Bolt
e (x2) f (x3)
EVA Pad B Support Plate Grommet Base Plate
o (x1) p (x1)
m
b
i m
b
m
c
g
b
i
M8x12 Bolt M6 Nut
g (x2) h (x2)
Wire Clip
q (x1) r (x1)
Option B : Grommet Base Installation
1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14 Bolt a
c
and tighten with Allen Key 3mm .
i
q
n
Stick the EVA pad A o to n
q
the Grommet Base Plate
f
i
RT OF MONITOR OR STAND.
Allen Key M4x12 Bolt
i (x1) j (x8)
Wire Clip
s (x4)
q
f
a
q