Wali M002XL Installation Manual

INSTALLATION MANUAL
Extra Tall Dual Monitor Mount
M002XL
Supplied Parts List
Lower Pole Upper Pole C-Clamp
a1 (x1) a2 (x1) b (x1)
M10 Washer Spring Washer Grommet Base Plate
k (x1) l (x1) m (x1)
Option B :16.3'' Pole Installation
t
Press Pole Cover T into the top of Lower Pole a1 .
t a1
Pre-Assembly
a1
a1
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
75x75\100x100
C-Clamp Brace Swivel Arm VESA Plate
c (x1) d (x1) e (x2)
Wire Clip Wire Clip Allen Key
n1 (x2) n2 (x4) o (x1)
2
Option A : Clamp Installation
1. Connect Lower Pole a and C-Clamp Brace c from the bottom using M5x14
Bolt f and tighten with Allen Key 3mm o . f
t
t
WARNING
！
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
(10kg/22lbs)x2
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt M8x12 Bolt Nut
f (x3) g (x2) h (x2)
Wrench M4x12 Bolt M4x30 Bolt
p (x1) q (x8) r (x8)
a1
c
o
a1
c
f
o
1
Option A :31.5'' Pole Installation
Loosen the screw on the Lower Pole
Lower Pole
2mm o to fix the two poles. o
Pre-Assembly
M10 Bolt Support Plate
i (x1) j (x1)
a1
M4 Spacer Pole Cover
s (x8) t (x1)
2. Select the preferred height according to your desk thickness. Connect C-Clamp b to C-Clamp
Brace c using M8x12 Bolt g and tighten with Allen Key 5mm o . Rotate the hand knob c g
clockwise to fasten for stability.
b
Hand Knob
a1 a1 with Allen key 2mm o . Connect o
a1 a1 to Upper Pole a2 a2 and tighten the screw with Allen key
a2
a2
o
o
a1
a1
b
o
c
g
o