HMS Networks Anybus Wireless Bridge II Serial AWB3005 Startup Manual page 20

®
Anybus Wireless Bridge II Serial
5.4. Easy Config Using the MODE Button
Figure 7. Easy Config Using the MODE Button
1. Power on the unit and wait for the Link Quality LEDs to light up and go out again,
then immediately press and release the MODE button.
2. Press MODE repeatedly to cycle through the Easy Config modes until the desired
mode is indicated by the A-B-C-D LEDs.
3. Within 20 seconds of step 2, press and hold MODE for 2 seconds. When the button is
released the unit will restart in the selected mode.
See also Available Easy Config Modes (page
Page 18 of 28
™
19).
Easy Config Using the MODE Button
SP2966 1.4