Remote Control; Web Control - Pioneer VSX-1120-K Operating Instructions Manual

12 Additional information
Symptom
2 DIGITAL or DTS does not
light when playing Dolby/DTS
software.
When playing Dolby Digital or
DTS sources, the receiver's
format indicators do not light.
When playing certain discs,
none of the receiver's format
indicators light.
When playing a disc with the
listening mode set to Auto
Surround or ALC, 2 PL II or
Neo:6 appear on the receiver.
During playback of DVD-Audio,
the display shows PCM.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the power
does not turn on.

Remote control

Symptom
Cannot be remote controlled.
Other components can't be
operated with the system
remote.

Web Control

Symptoms
Top Menu screen is not
displayed on browser.
Receiver cannot be operated
from browser.
Receiver's power does not
turn on when the power is
turned on using the Web
Control function.
90
En
Remedy
• These indicators do not light if playback is paused.
• Check the playback (especially the digital output) settings of the source component.
• Check that the player is connected using a digital connection.
• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the input signal on page 51).
• Check that the player isn't set up so that Dolby Digital and DTS sources are converted to PCM.
• Ensure that if there are several audio tracks on the disc, the Dolby Digital or DTS is selected.
• The disc may not contain 5.1/6.1 channel material. Check the disc packaging for more on what
audio tracks are recorded on the disc.
• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the input signal on page 51).
• If a two channel soundtrack is currently playing (including Dolby Surround encoded), then this is
not a malfunction. Check the disc packaging for details about the audio tracks available.
• This will occur when playing DVD-Audio material over the HDMI connection. This is not a
malfunction.
• See the Power section (page 85).
Remedy
• Set the remote control unit's remote control mode so that it matches the setting on the main unit
(see Operating multiple receivers on page 62).
• Check whether the receiver's remote control mode is properly set (see Remote Control Mode Setup
on page 83).
• Try replacing the batteries in the remote control (see Loading the batteries on page 10).
• Be sure to operate within 7 m (23 feet) and a 30º angle of the remote sensor on the front panel (see
Operating range of remote control unit on page 10).
• Check that there are no obstacles between the receiver and the remote control.
• Make sure that there is no fluorescent or other strong light shining on to the remote sensor.
• Check the connections of the CONTROL IN jacks (see Operating other Pioneer components with
this unit's sensor on page 34).
• If the battery ran down, the preset codes may have been cleared. Re-enter the preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset codes.
• When commands from the remote control units of other devices are registered using the learning
function, in some cases they may not be learned properly. In this case, register the commands again
using the learning function (see Programming signals from other remote controls on page 63). If they
still do not work, they may be in a special format that cannot be registered on this receiver's remote
control. Operate the device using another remote control.
Causes
This receiver's IP address has not been entered
into the browser correctly.
JavaScript is disabled on the internet browser.
The browser is not compatible with JavaScript.
Network Standby at Network Setup is set to
OFF.
Remedies
Check the receiver's IP address and enter it
correctly in the browser (page 81).
Enable JavaScript.
Use an internet browser that is compatible with
JavaScript.
Set Network Standby at Network Setup to ON
(page 82).