Using The Web Control Function; Checking Your System Settings; Resetting The System - Pioneer VSX-1120-K Operating Instructions Manual

08 Using other functions

Using the Web Control function

The receiver can be operated using a browser from a
computer connected on the same LAN as the receiver.
1 Turn on the computer and launch the Internet
browser.
2 In the address bar on the browser, enter the IP
address assigned to this receiver.
For example, if the IP address of this receiver is
"192.168.0.2", enter "http://192.168.0.2/".
When the connection is made with the receiver, a Top
Menu will be displayed.
This receiver's IP address can be found in the 'IP address,
Proxy' menu (page 81).
3 Once the Top Menu is displayed, click the button for
the zone you want to operate.
4 Operate from the screen for the individual zone.
• Even when the receiver is in the standby mode, it can
be turned on using the Web Control function. For
details, see Network Standby on page 82.
Web Control
Main ZONE
POWER
INPUT SELECT
LISTENING MODE
AUTO SURR/ALC/
STREAM DIRECT
60
En
ZONE 2 ZONE 3
ON OFF VOLUME -60.0dB MUTE
DVD
STEREO
HOME STANDARD ADVANCED
STEREO
THX SURROUND SURROUND

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press RECEIVER
system settings.
The front panel display shows each of the following
settings for three seconds each: Input function,
Sampling Frequency, MCACC preset, ZONE 2 input
and HDMI OUT.
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
Top Menu
2 While holding down ENTER on the front panel,
press  STANDBY/ON.
The display shows RESET  NO .
Select 'RESET' using PRESET /, then press
3
ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
, then press STATUS to check the