Operating Other Pioneer Components With This Unit's Sensor; Plugging In The Receiver - Pioneer VSX-1120-K Operating Instructions Manual

03 Connecting your equipment
Operating other Pioneer components
with this unit's sensor
Many Pioneer components have SR CONTROL jacks
which can be used to link components together so that
you can use just the remote sensor of one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
Important
• Note that if you use this feature, make sure that you
also have at least one set of analog audio, video or
HDMI jacks connected to another component for
grounding purposes.
1 Decide which component you want to use the
remote sensor of.
When you want to control any component in the chain,
this is the remote sensor at which you'll point the
corresponding remote control.
2 Connect the CONTROL OUT jack of that component
to the CONTROL IN jack of another Pioneer component.
Use a cable with a mono mini-plug on each end for the
connection.
Continue the chain in the same way for as many
components as you have.
Note
1 • If you want to control all your components using this receiver's remote control, see Setting the remote to control other components on
page 62.
• If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won't be able to control this unit using the
remote sensor.
2 After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You cannot carry out any
operations during this process. The HDMI indicator in the front panel display blinks during this process, and you can turn on this receiver
once it has stopped blinking. When you set the Control with HDMI to OFF, you can skip this process. For details about the Control with HDMI
feature, see Control with HDMI function on page 52.
34
En
OUT IN
Y P P
B R
MONITOR
OUT
AM LOOP FM UNBAL 75 SPEAKERS
Class 2 Wiring
RS-232C
ANTENNA
IN
(OUTPUT
5 V
IN OUT
150 mA
MAX) OUT
CONTROL IR
EXTENSION
IN OUT
IN
CONTROL CONTROL

Plugging in the receiver

Only plug in after you have connected all your
components to this receiver, including the speakers.
1 Plug the supplied power cord into the AC IN socket
on the back of the receiver.
1
2 Plug the other end into a power outlet.
CAUTION
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
IN
• Do not use the supplied power cord for any purpose
other than that described below.
A
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, e.g., when on vacation.
• Make sure the blue  STANDBY/ON light has gone
out before unplugging.
• If you have connected speakers with a 6
impedance, change the impedance setting before
turning on the power.
OUT
2
Ω