Exmark TURF TRACER HYDRO Operator's Manual page 25

A
CAUTION
• It is essential that all Operator
Safety Mechanisms be connected and
in proper operating conditions prior
to the use of the mower.
A
CAUTION
* When checking starting problems, be
sure to keep clear of areas with
moving parts.
5.1.5 Check for loose hardware.
Service Interval: Daily
a) Stop engine and remove ignition key.
b) Visually inspect machine for any loose hardware or any
other possible problem. Tighten hardware or correct the
problem before operating.
5.1.6 Service pre-cleaner element and air cleaner.
Service Interval: See Engine Owner's Manual
A
CAUTION
• Never do maintenance or repairs
near a hot engine. Always allow
engine time to cool down.
5.1.7 Change engine oil.
Service Interval: See Engine Owner's Manual
NOTE: Change oil after first five (5) hours of operation.
a) Disengage electric blade clutch.
b) Stop engine and remove ignition key.
c) Drain oil while engine is warm from operation.
d) Remove the oil drain plug from the right hand side of
the engine. Allow oil to drain, then replace drain plug.
e) Replace the oil filter as per Engine Owner's Manual.
Clean around oil filter and unscrew filter to remove.
Before reinstalling new filter, apply a thin coating of
oil on the surface of the rubber seal. Turn filter
clockwise until rubber seal contacts the filter adapter
then tighten filter an additional 2/3 to 3/4 turn.
f) Clean around oil fill cap and remove cap. Fill to the
specified capacity and replace cap. Use oil as specified
in Engine Owners Manual.
Do not overfill.
g) Start the engine and check for leaks. Stop engine and
recheck oil level.
5.1.8 Check hydraulic oil level.
Service Interval: 25 hr.
a) Stop engine.
- 20 -