Bluetti EP600 Quick Manual
Hide thumbs
Also See for EP600:
- Quick start manual ,
- Installation manual (113 pages) ,
- User manual (88 pages)
Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Bluetti EP600
Summary of Contents for Bluetti EP600
- Page 1 EP600 off-grid Parallel Connection Quick Guide...
- Page 2 1.Important Notes : The installation must be performed by a licensed electrician. Improper installation may result in death or serious injury and property damage. 2.The required cables are the following： 3.The steps as follows： 1.Binding device 2. Firmware Upgrade (one by one) 3.
- Page 3 4.The final batteries and communication wiring diagram is as follows, please follow this quick guide to finish the work. 5.Assemble and install Turn off all switches on the inverter and batteries to prevent electric shock！ 5.1 Binding 1) Tap Add Device on the Home page, or tap My Devices > Add Device > Add Manually. 2) On the Bind page, select your device from the Available Devices list, and tap OK to complete the binding.
- Page 4 Note: Only available when you connect to the EP600 ESS via Bluetooth. ● For a stable connection, keep your phone and EP600 ESS close together ● (recommended range: 5m). During the upgrade, you cannot perform charging, discharging, or any other operations.
- Page 5 5.3 Distinguish between Master and slave devices Once both devices are bound, go to the main interface of the app and click on Parallel, then you can see the name of the product corresponding to that serial number, and then write down the names of the two products.
- Page 6 Slave and one on the right being the Master. Note: The smaller serial NO. of EP600 is the Master ,and the CTs are connecting on the Master. Master: EP6002251000340163 ( just for example) EP6002326000001749 ( just for example)
- Page 7 Step 2 : Remove the IOT box of the slave, i.e. the EP600 on the left. Step 3 : Remove the signal cable (connecting EP600 and B500) from the Master, i.e. the EP600 on the right.
- Page 8 Step 4 : Connect the red and black battery cables Step5 : Connect the two new communication lines as shown below...
- Page 9 Details as following :...
- Page 10 NOTE: The final batteries and communication wiring diagram is as follows,please check it ： 5.6: Turns on the Batteries...
- Page 11 5.7 Turns on the system in the APP system switch, turn on Off-grid Parallel APP turn on the inside Pro Mode...
Need help?
Do you have a question about the EP600 and is the answer not in the manual?
Questions and answers